summaryrefslogblamecommitdiffstats
path: root/dts/Bindings/gpio/gpio-omap.txt
blob: e57b2cb28f6c903a16d5a87fc3f08f70cf7d0dd6 (plain) (tree)
1
2
3
4
5
6
7
8
9






                                         

                                                                           












                                                                        

                                                                       










                                                                        
                      
                                 

                              



                           
                      
  
OMAP GPIO controller bindings

Required properties:
- compatible:
  - "ti,omap2-gpio" for OMAP2 controllers
  - "ti,omap3-gpio" for OMAP3 controllers
  - "ti,omap4-gpio" for OMAP4 controllers
- reg : Physical base address of the controller and length of memory mapped
  region.
- gpio-controller : Marks the device node as a GPIO controller.
- #gpio-cells : Should be two.
  - first cell is the pin number
  - second cell is used to specify optional parameters (unused)
- interrupt-controller: Mark the device node as an interrupt controller.
- #interrupt-cells : Should be 2.
  The first cell is the GPIO number.
  The second cell is used to specify flags:
    bits[3:0] trigger type and level flags:
      1 = low-to-high edge triggered.
      2 = high-to-low edge triggered.
      4 = active high level-sensitive.
      8 = active low level-sensitive.
- interrupts : The interrupt the controller is rising as output when an
  interrupt occures

OMAP specific properties:
- ti,hwmods:		Name of the hwmod associated to the GPIO:
			"gpio<X>", <X> being the 1-based instance number
			from the HW spec.
- ti,gpio-always-on: 	Indicates if a GPIO bank is always powered and
			so will never lose its logic state.


Example:

gpio0: gpio@44e07000 {
    compatible = "ti,omap4-gpio";
    reg = <0x44e07000 0x1000>;
    ti,hwmods = "gpio1";
    gpio-controller;
    #gpio-cells = <2>;
    interrupt-controller;
    #interrupt-cells = <2>;
    interrupts = <96>;
};