dts: update to v5.4-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 0 insertions, 71 deletions

diff --git a/dts/Bindings/fieldbus/arcx,anybus-controller.txt b/dts/Bindings/fieldbus/arcx,anybus-controller.txt
deleted file mode 100644
index b1f9474f36..0000000000
--- a/dts/Bindings/fieldbus/arcx,anybus-controller.txt
+++ /dev/null
@@ -1,71 +0,0 @@
-* Arcx Anybus-S controller
-
-This chip communicates with the SoC over a parallel bus. It is
-expected that its Device Tree node is specified as the child of a node
-corresponding to the parallel bus used for communication.
-
-Required properties:
---------------------
-
-  - compatible : The following chip-specific string:
-        "arcx,anybus-controller"
-
-  - reg : three areas:
-	index 0: bus memory area where the cpld registers are located.
-	index 1: bus memory area of the first  host's dual-port ram.
-	index 2: bus memory area of the second host's dual-port ram.
-
-  - reset-gpios : the GPIO pin connected to the reset line of the controller.
-
-  - interrupts : two interrupts:
-		index 0: interrupt connected to the first  host
-		index 1: interrupt connected to the second host
-	Generic interrupt client node bindings are described in
-	interrupt-controller/interrupts.txt
-
-Optional: use of subnodes
--------------------------
-
-The card connected to a host may need additional properties. These can be
-specified in subnodes to the controller node.
-
-The subnodes are identified by the standard 'reg' property. Which information
-exactly can be specified depends on the bindings for the function driver
-for the subnode.
-
-Required controller node properties when using subnodes:
-- #address-cells: should be one.
-- #size-cells: should be zero.
-
-Required subnode properties:
-- reg: Must contain the host index of the card this subnode describes:
-		<0>	for the first  host on the controller
-		<1>	for the second host on the controller
-	Note that only a single card can be plugged into a host, so the host
-	index uniquely describes the card location.
-
-Example of usage:
------------------
-
-This example places the bridge on top of the i.MX WEIM parallel bus, see:
-Documentation/devicetree/bindings/bus/imx-weim.txt
-
-&weim {
-	controller@0,0 {
-		compatible = "arcx,anybus-controller";
-		reg = <0 0 0x100>, <0 0x400000 0x800>, <1 0x400000 0x800>;
-		reset-gpios = <&gpio5 2 GPIO_ACTIVE_HIGH>;
-		interrupt-parent = <&gpio1>;
-		interrupts = <1 IRQ_TYPE_LEVEL_LOW>, <5 IRQ_TYPE_LEVEL_LOW>;
-		/* fsl,weim-cs-timing is a i.MX WEIM bus specific property */
-		fsl,weim-cs-timing = <0x024400b1 0x00001010 0x20081100
-				0x00000000 0xa0000240 0x00000000>;
-		/* optional subnode for a card plugged into the first host */
-		#address-cells = <1>;
-		#size-cells = <0>;
-		card@0 {
-			reg = <0>;
-			/* card specific properties go here */
-		};
-	};
-};