dts: update to v4.19-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 35 insertions, 0 deletions

diff --git a/dts/Bindings/gpio/mediatek,mt7621-gpio.txt b/dts/Bindings/gpio/mediatek,mt7621-gpio.txt
new file mode 100644
index 0000000000..ba455589f8
--- /dev/null
+++ b/dts/Bindings/gpio/mediatek,mt7621-gpio.txt
@@ -0,0 +1,35 @@
+Mediatek MT7621 SoC GPIO controller bindings
+
+The IP core used inside these SoCs has 3 banks of 32 GPIOs each.
+The registers of all the banks are interwoven inside one single IO range.
+We load one GPIO controller instance per bank. Also the GPIO controller can receive
+interrupts on any of the GPIOs, either edge or level. It then interrupts the CPU
+using GIC INT12.
+
+Required properties for the top level node:
+- #gpio-cells : Should be two. The first cell is the GPIO pin number and the
+   second cell specifies GPIO flags, as defined in <dt-bindings/gpio/gpio.h>.
+   Only the GPIO_ACTIVE_HIGH and GPIO_ACTIVE_LOW flags are supported.
+- #interrupt-cells : Specifies the number of cells needed to encode an
+   interrupt. Should be 2. The first cell defines the interrupt number,
+   the second encodes the triger flags encoded as described in
+   Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+- compatible:
+  - "mediatek,mt7621-gpio" for Mediatek controllers
+- reg : Physical base address and length of the controller's registers
+- interrupt-parent : phandle of the parent interrupt controller.
+- interrupts : Interrupt specifier for the controllers interrupt.
+- interrupt-controller : Mark the device node as an interrupt controller.
+- gpio-controller : Marks the device node as a GPIO controller.
+
+Example:
+	gpio@600 {
+		#gpio-cells = <2>;
+		#interrupt-cells = <2>;
+		compatible = "mediatek,mt7621-gpio";
+		gpio-controller;
+		interrupt-controller;
+		reg = <0x600 0x100>;
+		interrupt-parent = <&gic>;
+		interrupts = <GIC_SHARED 12 IRQ_TYPE_LEVEL_HIGH>;
+	};