dts: update to v4.18-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 10 insertions, 0 deletions

diff --git a/dts/Bindings/regulator/regulator.txt b/dts/Bindings/regulator/regulator.txt
index 2babe15b61..a7cd36877b 100644
--- a/dts/Bindings/regulator/regulator.txt
+++ b/dts/Bindings/regulator/regulator.txt
@@ -59,6 +59,11 @@ Optional properties:
 - regulator-initial-mode: initial operating mode. The set of possible operating
   modes depends on the capabilities of every hardware so each device binding
   documentation explains which values the regulator supports.
+- regulator-allowed-modes: list of operating modes that software is allowed to
+  configure for the regulator at run-time.  Elements may be specified in any
+  order.  The set of possible operating modes depends on the capabilities of
+  every hardware so each device binding document explains which values the
+  regulator supports.
 - regulator-system-load: Load in uA present on regulator that is not captured by
   any consumer request.
 - regulator-pull-down: Enable pull down resistor when the regulator is disabled.
@@ -68,6 +73,11 @@ Optional properties:
 	0: Disable active discharge.
 	1: Enable active discharge.
 	Absence of this property will leave configuration to default.
+- regulator-coupled-with: Regulators with which the regulator
+  is coupled. The linkage is 2-way - all coupled regulators should be linked
+  with each other. A regulator should not be coupled with its supplier.
+- regulator-coupled-max-spread: Max spread between voltages of coupled regulators
+  in microvolts.
 
 Deprecated properties:
 - regulator-compatible: If a regulator chip contains multiple