1 files changed, 0 insertions, 52 deletions
diff --git a/arch/arm/boards/karo-tx28/tx28.c b/arch/arm/boards/karo-tx28/tx28.c
index 3fb1fe9177..26dbc00790 100644
--- a/arch/arm/boards/karo-tx28/tx28.c
+++ b/arch/arm/boards/karo-tx28/tx28.c
@@ -99,55 +99,3 @@ static int tx28_devices_init(void)
 }
 
 device_initcall(tx28_devices_init);
-
-/**
-@page tx28 KARO's TX28 CPU module
-
-@section tx28_cpu_card The CPU module
-
-http://www.karo-electronics.de/
-
-This CPU card is based on a Freescale i.MX28 CPU. The card is shipped with:
-
-- 128 MiB synchronous dynamic RAM (DDR2 type), 200 MHz support
-- 128 MiB NAND K9F1G08U0A (3.3V type)
-- PCA9554 GPIO expander
-- DS1339 RTC
-- LAN8710 Phy
-
-@section tx28_basboards Supported baseboards
-
-Supported baseboards are:
-- KARO's Starterkit 5
-
-@section tx28_stk5_howto How to get barebox for 'KARO's Starterkit 5'
-
-Using the default configuration:
-
-@verbatim
-make ARCH=arm tx28stk5_defconfig
-@endverbatim
-
-Build the binary image:
-
-@verbatim
-make ARCH=arm CROSS_COMPILE=armv5compiler
-@endverbatim
-
-@note replace the armv5compiler with your ARM v5 cross compiler.
-
-@note To use the result, you also need the following resources from Freescale:
-- the 'bootlets' archive
-- the 'elftosb2' encryption tool
-- in the case you want to start @b barebox from an attached SD card the
-  'sdimage' tool from Freescale's 'uuc' archive.
-
-@section tx28_mlayout Memory layout when barebox is running:
-
-- 0x40000000 start of SDRAM
-- 0x40000100 start of kernel's boot parameters
-  - below malloc area: stack area
-  - below barebox: malloc area
-- 0x47000000 start of @b barebox
-
-*/