1 files changed, 238 insertions, 0 deletions
diff --git a/arch/arm/boards/sama5d3_xplained/init.c b/arch/arm/boards/sama5d3_xplained/init.c
new file mode 100644
index 0000000000..ae18863acd
--- /dev/null
+++ b/arch/arm/boards/sama5d3_xplained/init.c
@@ -0,0 +1,238 @@
+/*
+ * Copyright (C) 2014 Bo Shen <voice.shen@gmail.com>
+ *
+ * This program is free software; you can redistribute it and/or
+ * modify it under the terms of the GNU General Public License as
+ * published by the Free Software Foundation; either version 2 of
+ * the License, or (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ */
+
+#include <common.h>
+#include <net.h>
+#include <init.h>
+#include <environment.h>
+#include <asm/armlinux.h>
+#include <generated/mach-types.h>
+#include <partition.h>
+#include <fs.h>
+#include <fcntl.h>
+#include <io.h>
+#include <mach/hardware.h>
+#include <nand.h>
+#include <sizes.h>
+#include <linux/mtd/nand.h>
+#include <mach/board.h>
+#include <mach/at91sam9_smc.h>
+#include <gpio.h>
+#include <mach/io.h>
+#include <mach/iomux.h>
+#include <mach/at91_pmc.h>
+#include <mach/at91_rstc.h>
+#include <mach/at91sam9x5_matrix.h>
+#include <readkey.h>
+#include <poller.h>
+#include <linux/clk.h>
+#include <linux/phy.h>
+#include <linux/micrel_phy.h>
+
+#if defined(CONFIG_NAND_ATMEL)
+static struct atmel_nand_data nand_pdata = {
+	.ale		= 21,
+	.cle		= 22,
+	.det_pin	= -EINVAL,
+	.rdy_pin	= -EINVAL,
+	.enable_pin	= -EINVAL,
+	.ecc_mode	= NAND_ECC_HW,
+	.pmecc_sector_size = 512,
+	.pmecc_corr_cap = 4,
+#if defined(CONFIG_MTD_NAND_ATMEL_BUSWIDTH_16)
+	.bus_width_16	= 1,
+#endif
+	.on_flash_bbt	= 1,
+};
+
+static struct sam9_smc_config sama5d3_xplained_nand_smc_config = {
+	.ncs_read_setup		= 0,
+	.nrd_setup		= 1,
+	.ncs_write_setup	= 0,
+	.nwe_setup		= 1,
+
+	.ncs_read_pulse		= 6,
+	.nrd_pulse		= 4,
+	.ncs_write_pulse	= 5,
+	.nwe_pulse		= 3,
+
+	.read_cycle		= 6,
+	.write_cycle		= 5,
+
+	.mode			= AT91_SMC_READMODE | AT91_SMC_WRITEMODE | AT91_SMC_EXNWMODE_DISABLE,
+	.tdf_cycles		= 1,
+};
+
+static void ek_add_device_nand(void)
+{
+	struct clk *clk = clk_get(NULL, "smc_clk");
+
+	clk_enable(clk);
+
+	/* setup bus-width (8 or 16) */
+	if (nand_pdata.bus_width_16)
+		sama5d3_xplained_nand_smc_config.mode |= AT91_SMC_DBW_16;
+	else
+		sama5d3_xplained_nand_smc_config.mode |= AT91_SMC_DBW_8;
+
+	/* configure chip-select 3 (NAND) */
+	sam9_smc_configure(0, 3, &sama5d3_xplained_nand_smc_config);
+
+	at91_add_device_nand(&nand_pdata);
+}
+#else
+static void ek_add_device_nand(void) {}
+#endif
+
+#if defined(CONFIG_DRIVER_NET_MACB)
+static struct macb_platform_data gmac_pdata = {
+	.phy_interface = PHY_INTERFACE_MODE_RGMII,
+	.phy_addr = 7,
+};
+
+static struct macb_platform_data macb_pdata = {
+	.phy_interface = PHY_INTERFACE_MODE_RMII,
+	.phy_addr = 0,
+};
+
+static void ek_add_device_eth(void)
+{
+	at91_add_device_eth(0, &gmac_pdata);
+	at91_add_device_eth(1, &macb_pdata);
+}
+#else
+static void ek_add_device_eth(void) {}
+#endif
+
+#if defined(CONFIG_MCI_ATMEL)
+/*
+ * MCI (SD/MMC)
+ */
+static struct atmel_mci_platform_data mci0_data = {
+	.bus_width	= 8,
+	.detect_pin	= AT91_PIN_PE0,
+	.wp_pin		= -EINVAL,
+};
+
+static void ek_add_device_mci(void)
+{
+	/* MMC0 */
+	at91_add_device_mci(0, &mci0_data);
+}
+#else
+static void ek_add_device_mci(void) {}
+#endif
+
+#ifdef CONFIG_LED_GPIO
+struct gpio_led leds[] = {
+	{
+		.gpio	= AT91_PIN_PE23,
+		.active_low	= 1,
+		.led	= {
+			.name = "d2",
+		},
+	}, {
+		.gpio	= AT91_PIN_PE24,
+		.active_low	= 1,
+		.led	= {
+			.name = "d3",
+		},
+	},
+};
+
+static void ek_add_led(void)
+{
+	int i;
+
+	for (i = 0; i < ARRAY_SIZE(leds); i++) {
+		at91_set_gpio_output(leds[i].gpio, leds[i].active_low);
+		led_gpio_register(&leds[i]);
+	}
+	led_set_trigger(LED_TRIGGER_HEARTBEAT, &leds[0].led);
+}
+#else
+static void ek_add_led(void) {}
+#endif
+
+static int sama5d3_xplained_mem_init(void)
+{
+	at91_add_device_sdram(0);
+
+	return 0;
+}
+mem_initcall(sama5d3_xplained_mem_init);
+
+static const struct devfs_partition sama5d3_xplained_nand0_partitions[] = {
+	{
+		.offset = 0x00000,
+		.size = SZ_256K,
+		.flags = DEVFS_PARTITION_FIXED,
+		.name = "at91bootstrap_raw",
+		.bbname = "at91bootstrap",
+	}, {
+		.offset = DEVFS_PARTITION_APPEND, /* 256 KiB */
+		.size = SZ_256K + SZ_128K,
+		.flags = DEVFS_PARTITION_FIXED,
+		.name = "self_raw",
+		.bbname = "self0",
+	},
+	/* hole of 128 KiB */
+	{
+		.offset = SZ_512K + SZ_256K,
+		.size = SZ_256K,
+		.flags = DEVFS_PARTITION_FIXED,
+		.name = "env_raw",
+		.bbname = "env0",
+	}, {
+		.offset = DEVFS_PARTITION_APPEND, /* 1 MiB */
+		.size = SZ_256K,
+		.flags = DEVFS_PARTITION_FIXED,
+		.name = "env_raw1",
+		.bbname = "env1",
+	}, {
+		/* sentinel */
+	}
+};
+
+static int sama5d3_xplained_devices_init(void)
+{
+	ek_add_device_nand();
+	ek_add_led();
+	ek_add_device_eth();
+	ek_add_device_mci();
+
+	devfs_create_partitions("nand0", sama5d3_xplained_nand0_partitions);
+
+	return 0;
+}
+device_initcall(sama5d3_xplained_devices_init);
+
+static int sama5d3_xplained_console_init(void)
+{
+	barebox_set_model("Atmel sama5d3_xplained");
+	barebox_set_hostname("sama5d3_xplained");
+
+	at91_register_uart(0, 0);
+
+	return 0;
+}
+console_initcall(sama5d3_xplained_console_init);
+
+static int sama5d3_xplained_main_clock(void)
+{
+	at91_set_main_clock(12000000);
+
+	return 0;
+}
+pure_initcall(sama5d3_xplained_main_clock);