1 files changed, 0 insertions, 48 deletions
diff --git a/dts/Bindings/arm/spear/shirq.txt b/dts/Bindings/arm/spear/shirq.txt
deleted file mode 100644
index 715a013ed4..0000000000
--- a/dts/Bindings/arm/spear/shirq.txt
+++ /dev/null
@@ -1,48 +0,0 @@
-* SPEAr Shared IRQ layer (shirq)
-
-SPEAr3xx architecture includes shared/multiplexed irqs for certain set
-of devices. The multiplexor provides a single interrupt to parent
-interrupt controller (VIC) on behalf of a group of devices.
-
-There can be multiple groups available on SPEAr3xx variants but not
-exceeding 4. The number of devices in a group can differ, further they
-may share same set of status/mask registers spanning across different
-bit masks. Also in some cases the group may not have enable or other
-registers. This makes software little complex.
-
-A single node in the device tree is used to describe the shared
-interrupt multiplexor (one node for all groups). A group in the
-interrupt controller shares config/control registers with other groups.
-For example, a 32-bit interrupt enable/disable config register can
-accommodate up to 4 interrupt groups.
-
-Required properties:
-  - compatible: should be, either of
-     - "st,spear300-shirq"
-     - "st,spear310-shirq"
-     - "st,spear320-shirq"
-  - interrupt-controller: Identifies the node as an interrupt controller.
-  - #interrupt-cells: should be <1> which basically contains the offset
-    (starting from 0) of interrupts for all the groups.
-  - reg: Base address and size of shirq registers.
-  - interrupts: The list of interrupts generated by the groups which are
-    then connected to a parent interrupt controller. Each group is
-    associated with one of the interrupts, hence number of interrupts (to
-    parent) is equal to number of groups. The format of the interrupt
-    specifier depends in the interrupt parent controller.
-
-  Optional properties:
-  - interrupt-parent: pHandle of the parent interrupt controller, if not
-    inherited from the parent node.
-
-Example:
-
-The following is an example from the SPEAr320 SoC dtsi file.
-
-shirq: interrupt-controller@0xb3000000 {
-	compatible = "st,spear320-shirq";
-	reg = <0xb3000000 0x1000>;
-	interrupts = <28 29 30 1>;
-	#interrupt-cells = <1>;
-	interrupt-controller;
-};