1 files changed, 0 insertions, 66 deletions
diff --git a/dts/Bindings/display/bridge/ti,tfp410.txt b/dts/Bindings/display/bridge/ti,tfp410.txt
deleted file mode 100644
index 5ff4f64ef8..0000000000
--- a/dts/Bindings/display/bridge/ti,tfp410.txt
+++ /dev/null
@@ -1,66 +0,0 @@
-TFP410 DPI to DVI encoder
-=========================
-
-Required properties:
-- compatible: "ti,tfp410"
-
-Optional properties:
-- powerdown-gpios: power-down gpio
-- reg: I2C address. If and only if present the device node should be placed
-  into the I2C controller node where the TFP410 I2C is connected to.
-- ti,deskew: data de-skew in 350ps increments, from -4 to +3, as configured
-  through th DK[3:1] pins. This property shall be present only if the TFP410
-  is not connected through I2C.
-
-Required nodes:
-
-This device has two video ports. Their connections are modeled using the OF
-graph bindings specified in [1]. Each port node shall have a single endpoint.
-
-- Port 0 is the DPI input port. Its endpoint subnode shall contain a
-  pclk-sample and bus-width property and a remote-endpoint property as specified
-  in [1].
-  - If pclk-sample is not defined, pclk-sample = 0 should be assumed for
-    backward compatibility.
-  - If bus-width is not defined then bus-width = 24 should be assumed for
-    backward compatibility.
-    bus-width = 24: 24 data lines are connected and single-edge mode
-    bus-width = 12: 12 data lines are connected and dual-edge mode
-
-- Port 1 is the DVI output port. Its endpoint subnode shall contain a
-  remote-endpoint property is specified in [1].
-
-[1] Documentation/devicetree/bindings/media/video-interfaces.txt
-
-
-Example
--------
-
-tfp410: encoder@0 {
-	compatible = "ti,tfp410";
-	powerdown-gpios = <&twl_gpio 2 GPIO_ACTIVE_LOW>;
-	ti,deskew = <4>;
-
-	ports {
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		port@0 {
-			reg = <0>;
-
-			tfp410_in: endpoint@0 {
-				pclk-sample = <1>;
-				bus-width = <24>;
-				remote-endpoint = <&dpi_out>;
-			};
-		};
-
-		port@1 {
-			reg = <1>;
-
-			tfp410_out: endpoint@0 {
-				remote-endpoint = <&dvi_connector_in>;
-			};
-		};
-	};
-};