diff options
Diffstat (limited to 'dts/Bindings/iio/imu')
| -rw-r--r-- | dts/Bindings/iio/imu/bmi160.txt | 1 | ||||
| -rw-r--r-- | dts/Bindings/iio/imu/inv_mpu6050.txt | 2 | ||||
| -rw-r--r-- | dts/Bindings/iio/imu/st_lsm6dsx.txt | 1 |
3 files changed, 1 insertions, 3 deletions
diff --git a/dts/Bindings/iio/imu/bmi160.txt b/dts/Bindings/iio/imu/bmi160.txt index ae0112c7de..0c1c105fb5 100644 --- a/dts/Bindings/iio/imu/bmi160.txt +++ b/dts/Bindings/iio/imu/bmi160.txt @@ -9,7 +9,6 @@ Required properties: - spi-max-frequency : set maximum clock frequency (only for SPI) Optional properties: - - interrupt-parent : should be the phandle of the interrupt controller - interrupts : interrupt mapping for IRQ, must be IRQ_TYPE_LEVEL_LOW - interrupt-names : set to "INT1" if INT1 pin should be used as interrupt input, set to "INT2" if INT2 pin should be used instead diff --git a/dts/Bindings/iio/imu/inv_mpu6050.txt b/dts/Bindings/iio/imu/inv_mpu6050.txt index 5f4777e8cc..b2f27da847 100644 --- a/dts/Bindings/iio/imu/inv_mpu6050.txt +++ b/dts/Bindings/iio/imu/inv_mpu6050.txt @@ -6,12 +6,12 @@ Required properties: - compatible : should be one of "invensense,mpu6050" "invensense,mpu6500" + "invensense,mpu6515" "invensense,mpu9150" "invensense,mpu9250" "invensense,mpu9255" "invensense,icm20608" - reg : the I2C address of the sensor - - interrupt-parent : should be the phandle for the interrupt controller - interrupts: interrupt mapping for IRQ. It should be configured with flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. diff --git a/dts/Bindings/iio/imu/st_lsm6dsx.txt b/dts/Bindings/iio/imu/st_lsm6dsx.txt index ef8a8566c6..ea2d6e0ae4 100644 --- a/dts/Bindings/iio/imu/st_lsm6dsx.txt +++ b/dts/Bindings/iio/imu/st_lsm6dsx.txt @@ -20,7 +20,6 @@ Optional properties: IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line when it is not active, whereas a pull-up one is needed when interrupt line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. -- interrupt-parent: should be the phandle for the interrupt controller - interrupts: interrupt mapping for IRQ. It should be configured with flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. |