path: root/dts/Bindings/media/samsung-s5k6a3.txt
diff options
Diffstat (limited to 'dts/Bindings/media/samsung-s5k6a3.txt')
1 files changed, 33 insertions, 0 deletions
diff --git a/dts/Bindings/media/samsung-s5k6a3.txt b/dts/Bindings/media/samsung-s5k6a3.txt
new file mode 100644
index 000000000..cce01e82f
--- /dev/null
+++ b/dts/Bindings/media/samsung-s5k6a3.txt
@@ -0,0 +1,33 @@
+Samsung S5K6A3(YX) raw image sensor
+S5K6A3(YX) is a raw image sensor with MIPI CSI-2 and CCP2 image data interfaces
+and CCI (I2C compatible) control bus.
+Required properties:
+- compatible : "samsung,s5k6a3";
+- reg : I2C slave address of the sensor;
+- svdda-supply : core voltage supply;
+- svddio-supply : I/O voltage supply;
+- afvdd-supply : AF (actuator) voltage supply;
+- gpios : specifier of a GPIO connected to the RESET pin;
+- clocks : should contain list of phandle and clock specifier pairs
+ according to common clock bindings for the clocks described
+ in the clock-names property;
+- clock-names : should contain "extclk" entry for the sensor's EXTCLK clock;
+Optional properties:
+- clock-frequency : the frequency at which the "extclk" clock should be
+ configured to operate, in Hz; if this property is not
+ specified default 24 MHz value will be used.
+The common video interfaces bindings (see video-interfaces.txt) should be
+used to specify link to the image data receiver. The S5K6A3(YX) device
+node should contain one 'port' child node with an 'endpoint' subnode.
+Following properties are valid for the endpoint node:
+- data-lanes : (optional) specifies MIPI CSI-2 data lanes as covered in
+ video-interfaces.txt. The sensor supports only one data lane.