1 files changed, 0 insertions, 84 deletions
diff --git a/dts/Bindings/net/nfc/nfcmrvl.txt b/dts/Bindings/net/nfc/nfcmrvl.txt
deleted file mode 100644
index c9b35251bb..0000000000
--- a/dts/Bindings/net/nfc/nfcmrvl.txt
+++ /dev/null
@@ -1,84 +0,0 @@
-* Marvell International Ltd. NCI NFC Controller
-
-Required properties:
-- compatible: Should be:
-  - "marvell,nfc-uart" or "mrvl,nfc-uart" for UART devices
-  - "marvell,nfc-i2c" for I2C devices
-  - "marvell,nfc-spi" for SPI devices
-
-Optional SoC specific properties:
-- pinctrl-names: Contains only one value - "default".
-- pintctrl-0: Specifies the pin control groups used for this controller.
-- reset-n-io: Output GPIO pin used to reset the chip (active low).
-- hci-muxed: Specifies that the chip is muxing NCI over HCI frames.
-
-Optional UART-based chip specific properties:
-- flow-control: Specifies that the chip is using RTS/CTS.
-- break-control: Specifies that the chip needs specific break management.
-
-Optional I2C-based chip specific properties:
-- i2c-int-falling: Specifies that the chip read event shall be trigged on
-  		   falling edge.
-- i2c-int-rising: Specifies that the chip read event shall be trigged on
-  		  rising edge.
-
-Example (for ARM-based BeagleBoard Black with 88W8887 on UART5):
-
-&uart5 {
-
-	nfcmrvluart: nfcmrvluart@5 {
-		compatible = "marvell,nfc-uart";
-
-		reset-n-io = <&gpio3 16 0>;
-
-		hci-muxed;
-		flow-control;
-        }
-};
-
-
-Example (for ARM-based BeagleBoard Black with 88W8887 on I2C1):
-
-&i2c1 {
-	clock-frequency = <400000>;
-
-	nfcmrvli2c0: i2c@1 {
-		compatible = "marvell,nfc-i2c";
-
-		reg = <0x8>;
-
-		/* I2C INT configuration */
-		interrupt-parent = <&gpio3>;
-		interrupts = <21 0>;
-
-		/* I2C INT trigger configuration */
-		i2c-int-rising;
-
-		/* Reset IO */
-		reset-n-io = <&gpio3 19 0>;
-	};
-};
-
-
-Example (for ARM-based BeagleBoard Black on SPI0):
-
-&spi0 {
-
-	mrvlnfcspi0: spi@0 {
-		compatible = "marvell,nfc-spi";
-
-		reg = <0>;
-
-		/* SPI Bus configuration */
-		spi-max-frequency = <3000000>;
-		spi-cpha;
-		spi-cpol;
-
-		/* SPI INT configuration */
-		interrupt-parent = <&gpio1>;
-		interrupts = <17 0>;
-
-		/* Reset IO */
-       		reset-n-io = <&gpio3 19 0>;
-	};
-};