1 files changed, 0 insertions, 47 deletions
diff --git a/dts/Bindings/net/qca-qca7000-spi.txt b/dts/Bindings/net/qca-qca7000-spi.txt
deleted file mode 100644
index c74989c0d8..0000000000
--- a/dts/Bindings/net/qca-qca7000-spi.txt
+++ /dev/null
@@ -1,47 +0,0 @@
-* Qualcomm QCA7000 (Ethernet over SPI protocol)
-
-Note: The QCA7000 is useable as a SPI device. In this case it must be defined
-as a child of a SPI master in the device tree.
-
-Required properties:
-- compatible : Should be "qca,qca7000"
-- reg : Should specify the SPI chip select
-- interrupts : The first cell should specify the index of the source interrupt
-  and the second cell should specify the trigger type as rising edge
-- spi-cpha : Must be set
-- spi-cpol: Must be set
-
-Optional properties:
-- interrupt-parent : Specify the pHandle of the source interrupt
-- spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at.
-  Numbers smaller than 1000000 or greater than 16000000 are invalid. Missing
-  the property will set the SPI frequency to 8000000 Hertz.
-- local-mac-address: 6 bytes, MAC address
-- qca,legacy-mode : Set the SPI data transfer of the QCA7000 to legacy mode.
-  In this mode the SPI master must toggle the chip select between each data
-  word. In burst mode these gaps aren't necessary, which is faster.
-  This setting depends on how the QCA7000 is setup via GPIO pin strapping.
-  If the property is missing the driver defaults to burst mode.
-
-Example:
-
-/* Freescale i.MX28 SPI master*/
-ssp2: spi@80014000 {
-	#address-cells = <1>;
-	#size-cells = <0>;
-	compatible = "fsl,imx28-spi";
-	pinctrl-names = "default";
-	pinctrl-0 = <&spi2_pins_a>;
-	status = "okay";
-
-	qca7000: ethernet@0 {
-		compatible = "qca,qca7000";
-		reg = <0x0>;
-		interrupt-parent = <&gpio3>;      /* GPIO Bank 3 */
-		interrupts = <25 0x1>;            /* Index: 25, rising edge */
-		spi-cpha;                         /* SPI mode: CPHA=1 */
-		spi-cpol;                         /* SPI mode: CPOL=1 */
-		spi-max-frequency = <8000000>;    /* freq: 8 MHz */
-		local-mac-address = [ A0 B0 C0 D0 E0 F0 ];
-	};
-};