diff options
Diffstat (limited to 'dts/Bindings/reset/st,sti-powerdown.txt')
| -rw-r--r-- | dts/Bindings/reset/st,sti-powerdown.txt | 45 |
1 files changed, 0 insertions, 45 deletions
diff --git a/dts/Bindings/reset/st,sti-powerdown.txt b/dts/Bindings/reset/st,sti-powerdown.txt deleted file mode 100644 index 92527138bc..0000000000 --- a/dts/Bindings/reset/st,sti-powerdown.txt +++ /dev/null @@ -1,45 +0,0 @@ -STMicroelectronics STi family Sysconfig Peripheral Powerdown Reset Controller -============================================================================= - -This binding describes a reset controller device that is used to enable and -disable on-chip peripheral controllers such as USB and SATA, using -"powerdown" control bits found in the STi family SoC system configuration -registers. These have been grouped together into a single reset controller -device for convenience. - -The actual action taken when powerdown is asserted is hardware dependent. -However, when asserted it may not be possible to access the hardware's -registers and after an assert/deassert sequence the hardware's previous state -may no longer be valid. - -Please refer to reset.txt in this directory for common reset -controller binding usage. - -Required properties: -- compatible: Should be "st,stih407-powerdown" -- #reset-cells: 1, see below - -example: - - powerdown: powerdown-controller { - compatible = "st,stih407-powerdown"; - #reset-cells = <1>; - }; - - -Specifying powerdown control of devices -======================================= - -Device nodes should specify the reset channel required in their "resets" -property, containing a phandle to the powerdown device node and an -index specifying which channel to use, as described in reset.txt - -example: - - st_dwc3: dwc3@8f94000 { - resets = <&powerdown STIH407_USB3_POWERDOWN>, - }; - -Macro definitions for the supported reset channels can be found in: - -include/dt-bindings/reset/stih407-resets.h |