1 files changed, 0 insertions, 68 deletions
diff --git a/dts/Bindings/serial/nxp,sc16is7xx.txt b/dts/Bindings/serial/nxp,sc16is7xx.txt
deleted file mode 100644
index c1091a923a..0000000000
--- a/dts/Bindings/serial/nxp,sc16is7xx.txt
+++ /dev/null
@@ -1,68 +0,0 @@
-* NXP SC16IS7xx advanced Universal Asynchronous Receiver-Transmitter (UART)
-* i2c as bus
-
-Required properties:
-- compatible: Should be one of the following:
-  - "nxp,sc16is740" for NXP SC16IS740,
-  - "nxp,sc16is741" for NXP SC16IS741,
-  - "nxp,sc16is750" for NXP SC16IS750,
-  - "nxp,sc16is752" for NXP SC16IS752,
-  - "nxp,sc16is760" for NXP SC16IS760,
-  - "nxp,sc16is762" for NXP SC16IS762.
-- reg: I2C address of the SC16IS7xx device.
-- interrupts: Should contain the UART interrupt
-- clocks: Reference to the IC source clock.
-	OR (when there is no clock provider visible to the platform)
-- clock-frequency: The source clock frequency for the IC.
-
-Optional properties:
-- gpio-controller: Marks the device node as a GPIO controller.
-- #gpio-cells: Should be two. The first cell is the GPIO number and
-  the second cell is used to specify the GPIO polarity:
-    0 = active high,
-    1 = active low.
-
-Example:
-        sc16is750: sc16is750@51 {
-                compatible = "nxp,sc16is750";
-                reg = <0x51>;
-                clocks = <&clk20m>;
-                interrupt-parent = <&gpio3>;
-                interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
-                gpio-controller;
-                #gpio-cells = <2>;
-        };
-
-* spi as bus
-
-Required properties:
-- compatible: Should be one of the following:
-  - "nxp,sc16is740" for NXP SC16IS740,
-  - "nxp,sc16is741" for NXP SC16IS741,
-  - "nxp,sc16is750" for NXP SC16IS750,
-  - "nxp,sc16is752" for NXP SC16IS752,
-  - "nxp,sc16is760" for NXP SC16IS760,
-  - "nxp,sc16is762" for NXP SC16IS762.
-- reg: SPI chip select number.
-- interrupts: Specifies the interrupt source of the parent interrupt
-  controller. The format of the interrupt specifier depends on the
-  parent interrupt controller.
-- clocks: phandle to the IC source clock.
-
-Optional properties:
-- gpio-controller: Marks the device node as a GPIO controller.
-- #gpio-cells: Should be two. The first cell is the GPIO number and
-  the second cell is used to specify the GPIO polarity:
-    0 = active high,
-    1 = active low.
-
-Example:
-	sc16is750: sc16is750@0 {
-		compatible = "nxp,sc16is750";
-		reg = <0>;
-		clocks = <&clk20m>;
-		interrupt-parent = <&gpio3>;
-		interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
-		gpio-controller;
-		#gpio-cells = <2>;
-	};