diff options
Diffstat (limited to 'dts/Bindings/spi/spi-peripheral-props.yaml')
| -rw-r--r-- | dts/Bindings/spi/spi-peripheral-props.yaml | 44 |
1 files changed, 28 insertions, 16 deletions
diff --git a/dts/Bindings/spi/spi-peripheral-props.yaml b/dts/Bindings/spi/spi-peripheral-props.yaml index 5e32928c4f..15938f81fd 100644 --- a/dts/Bindings/spi/spi-peripheral-props.yaml +++ b/dts/Bindings/spi/spi-peripheral-props.yaml @@ -16,7 +16,7 @@ description: their own separate schema that should be referenced from here. maintainers: - - Pratyush Yadav <p.yadav@ti.com> + - Mark Brown <broonie@kernel.org> properties: reg: @@ -29,21 +29,6 @@ properties: description: Chip select used by the device. - spi-3wire: - $ref: /schemas/types.yaml#/definitions/flag - description: - The device requires 3-wire mode. - - spi-cpha: - $ref: /schemas/types.yaml#/definitions/flag - description: - The device requires shifted clock phase (CPHA) mode. - - spi-cpol: - $ref: /schemas/types.yaml#/definitions/flag - description: - The device requires inverse clock polarity (CPOL) mode. - spi-cs-high: $ref: /schemas/types.yaml#/definitions/flag description: @@ -59,6 +44,21 @@ properties: description: Maximum SPI clocking speed of the device in Hz. + spi-cs-setup-delay-ns: + description: + Delay in nanoseconds to be introduced by the controller after CS is + asserted. + + spi-cs-hold-delay-ns: + description: + Delay in nanoseconds to be introduced by the controller before CS is + de-asserted. + + spi-cs-inactive-delay-ns: + description: + Delay in nanoseconds to be introduced by the controller after CS is + de-asserted. + spi-rx-bus-width: description: Bus width to the SPI bus used for read transfers. @@ -71,6 +71,11 @@ properties: description: Delay, in microseconds, after a read transfer. + rx-sample-delay-ns: + description: SPI Rx sample delay offset, unit is nanoseconds. + The delay from the default sample time before the actual + sample of the rxd input signal occurs. + spi-tx-bus-width: description: Bus width to the SPI bus used for write transfers. @@ -108,9 +113,16 @@ properties: minItems: 2 maxItems: 4 + st,spi-midi-ns: + description: | + Only for STM32H7, (Master Inter-Data Idleness) minimum time + delay in nanoseconds inserted between two consecutive data frames. + # The controller specific properties go here. allOf: + - $ref: arm,pl022-peripheral-props.yaml# - $ref: cdns,qspi-nor-peripheral-props.yaml# - $ref: samsung,spi-peripheral-props.yaml# + - $ref: nvidia,tegra210-quad-peripheral-props.yaml# additionalProperties: true |