1 files changed, 0 insertions, 65 deletions
diff --git a/dts/Bindings/spmi/qcom,spmi-pmic-arb.txt b/dts/Bindings/spmi/qcom,spmi-pmic-arb.txt
deleted file mode 100644
index ca645e21fe..0000000000
--- a/dts/Bindings/spmi/qcom,spmi-pmic-arb.txt
+++ /dev/null
@@ -1,65 +0,0 @@
-Qualcomm SPMI Controller (PMIC Arbiter)
-
-The SPMI PMIC Arbiter is found on Snapdragon chipsets.  It is an SPMI
-controller with wrapping arbitration logic to allow for multiple on-chip
-devices to control a single SPMI master.
-
-The PMIC Arbiter can also act as an interrupt controller, providing interrupts
-to slave devices.
-
-See Documentation/devicetree/bindings/spmi/spmi.yaml for the generic SPMI
-controller binding requirements for child nodes.
-
-See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
-generic interrupt controller binding documentation.
-
-Required properties:
-- compatible : should be "qcom,spmi-pmic-arb".
-- reg-names  : must contain:
-     "core" - core registers
-     "intr" - interrupt controller registers
-     "cnfg" - configuration registers
-   Registers used only for V2 PMIC Arbiter:
-     "chnls"  - tx-channel per virtual slave registers.
-     "obsrvr" - rx-channel (called observer) per virtual slave registers.
-
-- reg : address + size pairs describing the PMIC arb register sets; order must
-        correspond with the order of entries in reg-names
-- #address-cells : must be set to 2
-- #size-cells : must be set to 0
-- qcom,ee : indicates the active Execution Environment identifier (0-5)
-- qcom,channel : which of the PMIC Arb provided channels to use for accesses (0-5)
-- interrupts : interrupt list for the PMIC Arb controller, must contain a
-               single interrupt entry for the peripheral interrupt
-- interrupt-names : corresponding interrupt names for the interrupts
-                    listed in the 'interrupts' property, must contain:
-     "periph_irq" - summary interrupt for PMIC peripherals
-- interrupt-controller : boolean indicator that the PMIC arbiter is an interrupt controller
-- #interrupt-cells :  must be set to 4. Interrupts are specified as a 4-tuple:
-    cell 1: slave ID for the requested interrupt (0-15)
-    cell 2: peripheral ID for requested interrupt (0-255)
-    cell 3: the requested peripheral interrupt (0-7)
-    cell 4: interrupt flags indicating level-sense information, as defined in
-            dt-bindings/interrupt-controller/irq.h
-
-Example:
-
-	spmi {
-		compatible = "qcom,spmi-pmic-arb";
-		reg-names = "core", "intr", "cnfg";
-		reg = <0xfc4cf000 0x1000>,
-		      <0xfc4cb000 0x1000>,
-		      <0xfc4ca000 0x1000>;
-
-		interrupt-names = "periph_irq";
-		interrupts = <0 190 0>;
-
-		qcom,ee = <0>;
-		qcom,channel = <0>;
-
-		#address-cells = <2>;
-		#size-cells = <0>;
-
-		interrupt-controller;
-		#interrupt-cells = <4>;
-	};