diff options
Diffstat (limited to 'dts/src/arm/qcom-msm8974-samsung-klte.dts')
| -rw-r--r-- | dts/src/arm/qcom-msm8974-samsung-klte.dts | 340 |
1 files changed, 331 insertions, 9 deletions
diff --git a/dts/src/arm/qcom-msm8974-samsung-klte.dts b/dts/src/arm/qcom-msm8974-samsung-klte.dts index d4dc982142..97352de913 100644 --- a/dts/src/arm/qcom-msm8974-samsung-klte.dts +++ b/dts/src/arm/qcom-msm8974-samsung-klte.dts @@ -4,6 +4,7 @@ #include <dt-bindings/gpio/gpio.h> #include <dt-bindings/input/input.h> #include <dt-bindings/pinctrl/qcom,pmic-gpio.h> +#include <dt-bindings/leds/common.h> / { model = "Samsung Galaxy S5"; @@ -11,6 +12,8 @@ aliases { serial0 = &blsp1_uart1; + sdhc1 = &sdhc_1; /* SDC1 eMMC slot */ + sdhc2 = &sdhc_2; /* SDC2 SD card slot */ }; chosen { @@ -145,7 +148,7 @@ }; pma8084_l19: l19 { - regulator-min-microvolt = <2900000>; + regulator-min-microvolt = <3300000>; regulator-max-microvolt = <3300000>; }; @@ -160,6 +163,9 @@ pma8084_l21: l21 { regulator-min-microvolt = <2950000>; regulator-max-microvolt = <2950000>; + + regulator-allow-set-load; + regulator-system-load = <200000>; }; pma8084_l22: l22 { @@ -203,6 +209,95 @@ }; }; + i2c-gpio-touchkey { + compatible = "i2c-gpio"; + #address-cells = <1>; + #size-cells = <0>; + sda-gpios = <&msmgpio 95 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + scl-gpios = <&msmgpio 96 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + pinctrl-names = "default"; + pinctrl-0 = <&i2c_touchkey_pins>; + + touchkey@20 { + compatible = "cypress,tm2-touchkey"; + reg = <0x20>; + + interrupt-parent = <&pma8084_gpios>; + interrupts = <6 IRQ_TYPE_EDGE_FALLING>; + pinctrl-names = "default"; + pinctrl-0 = <&touchkey_pin>; + + vcc-supply = <&max77826_ldo15>; + vdd-supply = <&pma8084_l19>; + + linux,keycodes = <KEY_APPSELECT KEY_BACK>; + }; + }; + + i2c-gpio-led { + compatible = "i2c-gpio"; + #address-cells = <1>; + #size-cells = <0>; + scl-gpios = <&msmgpio 121 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + sda-gpios = <&msmgpio 120 (GPIO_ACTIVE_HIGH | GPIO_OPEN_DRAIN)>; + pinctrl-names = "default"; + pinctrl-0 = <&i2c_led_gpioex_pins>; + + i2c-gpio,delay-us = <2>; + + gpio_expander: gpio@20 { + compatible = "nxp,pcal6416"; + reg = <0x20>; + + gpio-controller; + #gpio-cells = <2>; + + vcc-supply = <&pma8084_s4>; + + pinctrl-names = "default"; + pinctrl-0 = <&gpioex_pin>; + + reset-gpios = <&msmgpio 145 GPIO_ACTIVE_LOW>; + }; + + led-controller@30 { + compatible = "panasonic,an30259a"; + reg = <0x30>; + + #address-cells = <1>; + #size-cells = <0>; + + led@1 { + reg = <1>; + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_RED>; + }; + + led@2 { + reg = <2>; + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_GREEN>; + }; + + led@3 { + reg = <3>; + function = LED_FUNCTION_STATUS; + color = <LED_COLOR_ID_BLUE>; + }; + }; + }; + + vreg_wlan: wlan-regulator { + compatible = "regulator-fixed"; + + regulator-name = "wl-reg"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + + gpio = <&gpio_expander 8 GPIO_ACTIVE_HIGH>; + enable-active-high; + }; + /delete-node/ vreg-boost; }; @@ -258,9 +353,109 @@ bias-pull-up; }; }; + + sdhc2_pin_a: sdhc2-pin-active { + clk-cmd-data { + pins = "gpio35", "gpio36", "gpio37", "gpio38", + "gpio39", "gpio40"; + function = "sdc3"; + drive-strength = <8>; + bias-disable; + }; + }; + + sdhc2_cd_pin: sdhc2-cd { + pins = "gpio62"; + function = "gpio"; + + drive-strength = <2>; + bias-disable; + }; + + sdhc3_pin_a: sdhc3-pin-active { + clk { + pins = "sdc2_clk"; + drive-strength = <6>; + bias-disable; + }; + + cmd-data { + pins = "sdc2_cmd", "sdc2_data"; + drive-strength = <6>; + bias-pull-up; + }; + }; + + i2c2_pins: i2c2 { + mux { + pins = "gpio6", "gpio7"; + function = "blsp_i2c2"; + + drive-strength = <2>; + bias-disable; + }; + }; + + i2c6_pins: i2c6 { + mux { + pins = "gpio29", "gpio30"; + function = "blsp_i2c6"; + + drive-strength = <2>; + bias-disable; + }; + }; + + i2c12_pins: i2c12 { + mux { + pins = "gpio87", "gpio88"; + function = "blsp_i2c12"; + + drive-strength = <2>; + bias-disable; + }; + }; + + i2c_touchkey_pins: i2c-touchkey { + mux { + pins = "gpio95", "gpio96"; + function = "gpio"; + input-enable; + bias-pull-up; + }; + }; + + i2c_led_gpioex_pins: i2c-led-gpioex { + mux { + pins = "gpio120", "gpio121"; + function = "gpio"; + input-enable; + bias-pull-down; + }; + }; + + gpioex_pin: gpioex { + res { + pins = "gpio145"; + function = "gpio"; + + bias-pull-up; + drive-strength = <2>; + }; + }; + + wifi_pin: wifi { + int { + pins = "gpio92"; + function = "gpio"; + + input-enable; + bias-pull-down; + }; + }; }; - sdhci@f9824900 { + sdhc_1: sdhci@f9824900 { status = "ok"; vmmc-supply = <&pma8084_l20>; @@ -273,6 +468,55 @@ pinctrl-0 = <&sdhc1_pin_a>; }; + sdhc_2: sdhci@f9864900 { + status = "ok"; + + max-frequency = <100000000>; + + vmmc-supply = <&pma8084_l21>; + vqmmc-supply = <&pma8084_l13>; + + bus-width = <4>; + + /* cd-gpio is intentionally disabled. If enabled, an SD card + * present during boot is not initialized correctly. Without + * cd-gpios the driver resorts to polling, so hotplug works. + */ + pinctrl-names = "default"; + pinctrl-0 = <&sdhc2_pin_a /* &sdhc2_cd_pin */>; + // cd-gpios = <&msmgpio 62 GPIO_ACTIVE_LOW>; + }; + + sdhci@f98a4900 { + status = "okay"; + + #address-cells = <1>; + #size-cells = <0>; + + max-frequency = <100000000>; + + pinctrl-names = "default"; + pinctrl-0 = <&sdhc3_pin_a>; + + vmmc-supply = <&vreg_wlan>; + vqmmc-supply = <&pma8084_s4>; + + bus-width = <4>; + non-removable; + + wifi@1 { + reg = <1>; + compatible = "brcm,bcm4329-fmac"; + + interrupt-parent = <&msmgpio>; + interrupts = <92 IRQ_TYPE_LEVEL_HIGH>; + interrupt-names = "host-wake"; + + pinctrl-names = "default"; + pinctrl-0 = <&wlan_sleep_clk_pin &wifi_pin>; + }; + }; + usb@f9a55000 { status = "ok"; @@ -298,14 +542,38 @@ }; }; - pinctrl@fd510000 { - i2c6_pins: i2c6 { - mux { - pins = "gpio29", "gpio30"; - function = "blsp_i2c6"; + i2c@f9924000 { + status = "okay"; - drive-strength = <2>; - bias-disable; + pinctrl-names = "default"; + pinctrl-0 = <&i2c2_pins>; + + touchscreen@20 { + compatible = "syna,rmi4-i2c"; + reg = <0x20>; + + interrupt-parent = <&pma8084_gpios>; + interrupts = <8 IRQ_TYPE_EDGE_FALLING>; + + vdd-supply = <&max77826_ldo13>; + vio-supply = <&pma8084_lvs2>; + + pinctrl-names = "default"; + pinctrl-0 = <&touch_pin>; + + syna,startup-delay-ms = <100>; + + #address-cells = <1>; + #size-cells = <0>; + + rmi4-f01@1 { + reg = <0x1>; + syna,nosleep-mode = <1>; + }; + + rmi4-f12@12 { + reg = <0x12>; + syna,sensor-type = <1>; }; }; }; @@ -408,6 +676,27 @@ }; }; }; + + i2c@f9968000 { + status = "okay"; + + pinctrl-names = "default"; + pinctrl-0 = <&i2c12_pins>; + + fuelgauge@36 { + compatible = "maxim,max17048"; + reg = <0x36>; + + maxim,double-soc; + maxim,rcomp = /bits/ 8 <0x56>; + + interrupt-parent = <&pma8084_gpios>; + interrupts = <21 IRQ_TYPE_EDGE_FALLING>; + + pinctrl-names = "default"; + pinctrl-0 = <&fuelgauge_pin>; + }; + }; }; &spmi_bus { @@ -420,6 +709,39 @@ bias-pull-up; power-source = <PMA8084_GPIO_S4>; }; + + touchkey_pin: touchkey-int-pin { + pins = "gpio6"; + function = "normal"; + bias-disable; + input-enable; + power-source = <PMA8084_GPIO_S4>; + }; + + touch_pin: touchscreen-int-pin { + pins = "gpio8"; + function = "normal"; + bias-disable; + input-enable; + power-source = <PMA8084_GPIO_S4>; + }; + + wlan_sleep_clk_pin: wlan-sleep-clk-pin { + pins = "gpio16"; + function = "func2"; + + output-high; + power-source = <PMA8084_GPIO_S4>; + qcom,drive-strength = <PMIC_GPIO_STRENGTH_HIGH>; + }; + + fuelgauge_pin: fuelgauge-int-pin { + pins = "gpio21"; + function = "normal"; + bias-disable; + input-enable; + power-source = <PMA8084_GPIO_S4>; + }; }; }; }; |