diff options
Diffstat (limited to 'dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts')
| -rw-r--r-- | dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts | 325 |
1 files changed, 4 insertions, 321 deletions
diff --git a/dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts b/dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts index 2cacafd8fa..73e24cc55a 100644 --- a/dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts +++ b/dts/src/arm64/qcom/sc7280-herobrine-villager-r0.dts @@ -7,327 +7,10 @@ /dts-v1/; -#include "sc7280-herobrine.dtsi" +#include "sc7280-herobrine-villager.dtsi" +#include "sc7280-herobrine-lte-sku.dtsi" / { - model = "Google Villager (rev0+)"; - compatible = "google,villager", "qcom,sc7280"; -}; - -/* - * ADDITIONS TO FIXED REGULATORS DEFINED IN PARENT DEVICE TREE FILES - * - * Sort order matches the order in the parent files (parents before children). - */ - -&pp3300_codec { - status = "okay"; -}; - -/* ADDITIONS TO NODES DEFINED IN PARENT DEVICE TREE FILES */ - -ap_tp_i2c: &i2c0 { - status = "okay"; - clock-frequency = <400000>; - - trackpad: trackpad@2c { - compatible = "hid-over-i2c"; - reg = <0x2c>; - pinctrl-names = "default"; - pinctrl-0 = <&tp_int_odl>; - - interrupt-parent = <&tlmm>; - interrupts = <7 IRQ_TYPE_EDGE_FALLING>; - - hid-descr-addr = <0x20>; - vcc-supply = <&pp3300_z1>; - - wakeup-source; - }; -}; - -ts_i2c: &i2c13 { - status = "okay"; - clock-frequency = <400000>; - - ap_ts: touchscreen@10 { - compatible = "elan,ekth6915"; - reg = <0x10>; - pinctrl-names = "default"; - pinctrl-0 = <&ts_int_conn>, <&ts_rst_conn>; - - interrupt-parent = <&tlmm>; - interrupts = <55 IRQ_TYPE_LEVEL_LOW>; - - reset-gpios = <&tlmm 54 GPIO_ACTIVE_LOW>; - - vcc33-supply = <&ts_avdd>; - }; -}; - -&ap_sar_sensor_i2c { - status = "okay"; -}; - -&ap_sar_sensor0 { - status = "okay"; -}; - -&ap_sar_sensor1 { - status = "okay"; -}; - -&mdss_edp { - status = "okay"; -}; - -&mdss_edp_phy { - status = "okay"; -}; - -/* For nvme */ -&pcie1 { - status = "okay"; -}; - -/* For nvme */ -&pcie1_phy { - status = "okay"; -}; - -&pwmleds { - status = "okay"; -}; - -/* For eMMC */ -&sdhc_1 { - status = "okay"; -}; - -/* PINCTRL - ADDITIONS TO NODES IN PARENT DEVICE TREE FILES */ - -&ts_rst_conn { - bias-disable; -}; - -/* PINCTRL - BOARD-SPECIFIC */ - -/* - * Methodology for gpio-line-names: - * - If a pin goes to herobrine board and is named it gets that name. - * - If a pin goes to herobrine board and is not named, it gets no name. - * - If a pin is totally internal to Qcard then it gets Qcard name. - * - If a pin is not hooked up on Qcard, it gets no name. - */ - -&pm8350c_gpios { - gpio-line-names = "FLASH_STROBE_1", /* 1 */ - "AP_SUSPEND", - "PM8008_1_RST_N", - "", - "", - "", - "PMIC_EDP_BL_EN", - "PMIC_EDP_BL_PWM", - ""; -}; - -&tlmm { - gpio-line-names = "AP_TP_I2C_SDA", /* 0 */ - "AP_TP_I2C_SCL", - "SSD_RST_L", - "PE_WAKE_ODL", - "AP_SAR_SDA", - "AP_SAR_SCL", - "PRB_SC_GPIO_6", - "TP_INT_ODL", - "HP_I2C_SDA", - "HP_I2C_SCL", - - "GNSS_L1_EN", /* 10 */ - "GNSS_L5_EN", - "SPI_AP_MOSI", - "SPI_AP_MISO", - "SPI_AP_CLK", - "SPI_AP_CS0_L", - /* - * AP_FLASH_WP is crossystem ABI. Schematics - * call it BIOS_FLASH_WP_OD. - */ - "AP_FLASH_WP", - "", - "AP_EC_INT_L", - "", - - "UF_CAM_RST_L", /* 20 */ - "WF_CAM_RST_L", - "UART_AP_TX_DBG_RX", - "UART_DBG_TX_AP_RX", - "", - "PM8008_IRQ_1", - "HOST2WLAN_SOL", - "WLAN2HOST_SOL", - "MOS_BT_UART_CTS", - "MOS_BT_UART_RFR", - - "MOS_BT_UART_TX", /* 30 */ - "MOS_BT_UART_RX", - "PRB_SC_GPIO_32", - "HUB_RST_L", - "", - "", - "AP_SPI_FP_MISO", - "AP_SPI_FP_MOSI", - "AP_SPI_FP_CLK", - "AP_SPI_FP_CS_L", - - "AP_EC_SPI_MISO", /* 40 */ - "AP_EC_SPI_MOSI", - "AP_EC_SPI_CLK", - "AP_EC_SPI_CS_L", - "LCM_RST_L", - "EARLY_EUD_N", - "", - "DP_HOT_PLUG_DET", - "IO_BRD_MLB_ID0", - "IO_BRD_MLB_ID1", - - "IO_BRD_MLB_ID2", /* 50 */ - "SSD_EN", - "TS_I2C_SDA_CONN", - "TS_I2C_CLK_CONN", - "TS_RST_CONN", - "TS_INT_CONN", - "AP_I2C_TPM_SDA", - "AP_I2C_TPM_SCL", - "PRB_SC_GPIO_58", - "PRB_SC_GPIO_59", - - "EDP_HOT_PLUG_DET_N", /* 60 */ - "FP_TO_AP_IRQ_L", - "", - "AMP_EN", - "CAM0_MCLK_GPIO_64", - "CAM1_MCLK_GPIO_65", - "WF_CAM_MCLK", - "PRB_SC_GPIO_67", - "FPMCU_BOOT0", - "UF_CAM_SDA", - - "UF_CAM_SCL", /* 70 */ - "", - "", - "WF_CAM_SDA", - "WF_CAM_SCL", - "", - "", - "EN_FP_RAILS", - "FP_RST_L", - "PCIE1_CLKREQ_ODL", - - "EN_PP3300_DX_EDP", /* 80 */ - "SC_GPIO_81", - "FORCED_USB_BOOT", - "WCD_RESET_N", - "MOS_WLAN_EN", - "MOS_BT_EN", - "MOS_SW_CTRL", - "MOS_PCIE0_RST", - "MOS_PCIE0_CLKREQ_N", - "MOS_PCIE0_WAKE_N", - - "MOS_LAA_AS_EN", /* 90 */ - "SD_CD_ODL", - "", - "", - "MOS_BT_WLAN_SLIMBUS_CLK", - "MOS_BT_WLAN_SLIMBUS_DAT0", - "HP_MCLK", - "HP_BCLK", - "HP_DOUT", - "HP_DIN", - - "HP_LRCLK", /* 100 */ - "HP_IRQ", - "", - "", - "GSC_AP_INT_ODL", - "EN_PP3300_CODEC", - "AMP_BCLK", - "AMP_DIN", - "AMP_LRCLK", - "UIM1_DATA_GPIO_109", - - "UIM1_CLK_GPIO_110", /* 110 */ - "UIM1_RESET_GPIO_111", - "PRB_SC_GPIO_112", - "UIM0_DATA", - "UIM0_CLK", - "UIM0_RST", - "UIM0_PRESENT_ODL", - "SDM_RFFE0_CLK", - "SDM_RFFE0_DATA", - "WF_CAM_EN", - - "FASTBOOT_SEL_0", /* 120 */ - "SC_GPIO_121", - "FASTBOOT_SEL_1", - "SC_GPIO_123", - "FASTBOOT_SEL_2", - "SM_RFFE4_CLK_GRFC_8", - "SM_RFFE4_DATA_GRFC_9", - "WLAN_COEX_UART1_RX", - "WLAN_COEX_UART1_TX", - "PRB_SC_GPIO_129", - - "LCM_ID0", /* 130 */ - "LCM_ID1", - "", - "SDR_QLINK_REQ", - "SDR_QLINK_EN", - "QLINK0_WMSS_RESET_N", - "SMR526_QLINK1_REQ", - "SMR526_QLINK1_EN", - "SMR526_QLINK1_WMSS_RESET_N", - "PRB_SC_GPIO_139", - - "SAR1_IRQ_ODL", /* 140 */ - "SAR0_IRQ_ODL", - "PRB_SC_GPIO_142", - "", - "WCD_SWR_TX_CLK", - "WCD_SWR_TX_DATA0", - "WCD_SWR_TX_DATA1", - "WCD_SWR_RX_CLK", - "WCD_SWR_RX_DATA0", - "WCD_SWR_RX_DATA1", - - "DMIC01_CLK", /* 150 */ - "DMIC01_DATA", - "DMIC23_CLK", - "DMIC23_DATA", - "", - "", - "EC_IN_RW_ODL", - "HUB_EN", - "WCD_SWR_TX_DATA2", - "", - - "", /* 160 */ - "", - "", - "", - "", - "", - "", - "", - "", - "", - - "", /* 170 */ - "MOS_BLE_UART_TX", - "MOS_BLE_UART_RX", - "", - "", - ""; + model = "Google Villager (rev0)"; + compatible = "google,villager-rev0", "qcom,sc7280"; }; |