diff options
Diffstat (limited to 'dts/src/arm64/qcom/sc7280-herobrine-villager.dtsi')
| -rw-r--r-- | dts/src/arm64/qcom/sc7280-herobrine-villager.dtsi | 316 |
1 files changed, 316 insertions, 0 deletions
diff --git a/dts/src/arm64/qcom/sc7280-herobrine-villager.dtsi b/dts/src/arm64/qcom/sc7280-herobrine-villager.dtsi new file mode 100644 index 0000000000..38c8a3679f --- /dev/null +++ b/dts/src/arm64/qcom/sc7280-herobrine-villager.dtsi @@ -0,0 +1,316 @@ +// SPDX-License-Identifier: (GPL-2.0+ OR MIT) +/* + * Google Villager board device tree source + * + * Copyright 2022 Google LLC. + */ + +#include "sc7280-herobrine.dtsi" + +/* + * ADDITIONS TO FIXED REGULATORS DEFINED IN PARENT DEVICE TREE FILES + * + * Sort order matches the order in the parent files (parents before children). + */ + +&pp3300_codec { + status = "okay"; +}; + +/* ADDITIONS TO NODES DEFINED IN PARENT DEVICE TREE FILES */ + +ap_tp_i2c: &i2c0 { + status = "okay"; + clock-frequency = <400000>; + + trackpad: trackpad@2c { + compatible = "hid-over-i2c"; + reg = <0x2c>; + pinctrl-names = "default"; + pinctrl-0 = <&tp_int_odl>; + + interrupt-parent = <&tlmm>; + interrupts = <7 IRQ_TYPE_EDGE_FALLING>; + + hid-descr-addr = <0x20>; + vdd-supply = <&pp3300_z1>; + + wakeup-source; + }; +}; + +ts_i2c: &i2c13 { + status = "okay"; + clock-frequency = <400000>; + + ap_ts: touchscreen@10 { + compatible = "elan,ekth6915"; + reg = <0x10>; + pinctrl-names = "default"; + pinctrl-0 = <&ts_int_conn>, <&ts_rst_conn>; + + interrupt-parent = <&tlmm>; + interrupts = <55 IRQ_TYPE_LEVEL_LOW>; + + reset-gpios = <&tlmm 54 GPIO_ACTIVE_LOW>; + + vcc33-supply = <&ts_avdd>; + vccio-supply = <&ts_avccio>; + }; +}; + +&ap_sar_sensor_i2c { + status = "okay"; +}; + +&ap_sar_sensor0 { + status = "okay"; +}; + +&ap_sar_sensor1 { + status = "okay"; +}; + +&mdss_edp { + status = "okay"; +}; + +&mdss_edp_phy { + status = "okay"; +}; + +&pwmleds { + status = "okay"; +}; + +/* For eMMC */ +&sdhc_1 { + status = "okay"; +}; + +/* PINCTRL - ADDITIONS TO NODES IN PARENT DEVICE TREE FILES */ + +&ts_rst_conn { + bias-disable; +}; + +/* PINCTRL - BOARD-SPECIFIC */ + +/* + * Methodology for gpio-line-names: + * - If a pin goes to herobrine board and is named it gets that name. + * - If a pin goes to herobrine board and is not named, it gets no name. + * - If a pin is totally internal to Qcard then it gets Qcard name. + * - If a pin is not hooked up on Qcard, it gets no name. + */ + +&pm8350c_gpios { + gpio-line-names = "FLASH_STROBE_1", /* 1 */ + "AP_SUSPEND", + "PM8008_1_RST_N", + "", + "", + "", + "PMIC_EDP_BL_EN", + "PMIC_EDP_BL_PWM", + ""; +}; + +&tlmm { + gpio-line-names = "AP_TP_I2C_SDA", /* 0 */ + "AP_TP_I2C_SCL", + "SSD_RST_L", + "PE_WAKE_ODL", + "AP_SAR_SDA", + "AP_SAR_SCL", + "PRB_SC_GPIO_6", + "TP_INT_ODL", + "HP_I2C_SDA", + "HP_I2C_SCL", + + "GNSS_L1_EN", /* 10 */ + "GNSS_L5_EN", + "SPI_AP_MOSI", + "SPI_AP_MISO", + "SPI_AP_CLK", + "SPI_AP_CS0_L", + /* + * AP_FLASH_WP is crossystem ABI. Schematics + * call it BIOS_FLASH_WP_OD. + */ + "AP_FLASH_WP", + "", + "AP_EC_INT_L", + "", + + "UF_CAM_RST_L", /* 20 */ + "WF_CAM_RST_L", + "UART_AP_TX_DBG_RX", + "UART_DBG_TX_AP_RX", + "", + "PM8008_IRQ_1", + "HOST2WLAN_SOL", + "WLAN2HOST_SOL", + "MOS_BT_UART_CTS", + "MOS_BT_UART_RFR", + + "MOS_BT_UART_TX", /* 30 */ + "MOS_BT_UART_RX", + "PRB_SC_GPIO_32", + "HUB_RST_L", + "", + "", + "AP_SPI_FP_MISO", + "AP_SPI_FP_MOSI", + "AP_SPI_FP_CLK", + "AP_SPI_FP_CS_L", + + "AP_EC_SPI_MISO", /* 40 */ + "AP_EC_SPI_MOSI", + "AP_EC_SPI_CLK", + "AP_EC_SPI_CS_L", + "LCM_RST_L", + "EARLY_EUD_N", + "", + "DP_HOT_PLUG_DET", + "IO_BRD_MLB_ID0", + "IO_BRD_MLB_ID1", + + "IO_BRD_MLB_ID2", /* 50 */ + "SSD_EN", + "TS_I2C_SDA_CONN", + "TS_I2C_CLK_CONN", + "TS_RST_CONN", + "TS_INT_CONN", + "AP_I2C_TPM_SDA", + "AP_I2C_TPM_SCL", + "PRB_SC_GPIO_58", + "PRB_SC_GPIO_59", + + "EDP_HOT_PLUG_DET_N", /* 60 */ + "FP_TO_AP_IRQ_L", + "", + "AMP_EN", + "CAM0_MCLK_GPIO_64", + "CAM1_MCLK_GPIO_65", + "WF_CAM_MCLK", + "PRB_SC_GPIO_67", + "FPMCU_BOOT0", + "UF_CAM_SDA", + + "UF_CAM_SCL", /* 70 */ + "", + "", + "WF_CAM_SDA", + "WF_CAM_SCL", + "", + "", + "EN_FP_RAILS", + "FP_RST_L", + "PCIE1_CLKREQ_ODL", + + "EN_PP3300_DX_EDP", /* 80 */ + "SC_GPIO_81", + "FORCED_USB_BOOT", + "WCD_RESET_N", + "MOS_WLAN_EN", + "MOS_BT_EN", + "MOS_SW_CTRL", + "MOS_PCIE0_RST", + "MOS_PCIE0_CLKREQ_N", + "MOS_PCIE0_WAKE_N", + + "MOS_LAA_AS_EN", /* 90 */ + "SD_CD_ODL", + "", + "", + "MOS_BT_WLAN_SLIMBUS_CLK", + "MOS_BT_WLAN_SLIMBUS_DAT0", + "HP_MCLK", + "HP_BCLK", + "HP_DOUT", + "HP_DIN", + + "HP_LRCLK", /* 100 */ + "HP_IRQ", + "", + "", + "GSC_AP_INT_ODL", + "EN_PP3300_CODEC", + "AMP_BCLK", + "AMP_DIN", + "AMP_LRCLK", + "UIM1_DATA_GPIO_109", + + "UIM1_CLK_GPIO_110", /* 110 */ + "UIM1_RESET_GPIO_111", + "PRB_SC_GPIO_112", + "UIM0_DATA", + "UIM0_CLK", + "UIM0_RST", + "UIM0_PRESENT_ODL", + "SDM_RFFE0_CLK", + "SDM_RFFE0_DATA", + "WF_CAM_EN", + + "FASTBOOT_SEL_0", /* 120 */ + "SC_GPIO_121", + "FASTBOOT_SEL_1", + "SC_GPIO_123", + "FASTBOOT_SEL_2", + "SM_RFFE4_CLK_GRFC_8", + "SM_RFFE4_DATA_GRFC_9", + "WLAN_COEX_UART1_RX", + "WLAN_COEX_UART1_TX", + "PRB_SC_GPIO_129", + + "LCM_ID0", /* 130 */ + "LCM_ID1", + "", + "SDR_QLINK_REQ", + "SDR_QLINK_EN", + "QLINK0_WMSS_RESET_N", + "SMR526_QLINK1_REQ", + "SMR526_QLINK1_EN", + "SMR526_QLINK1_WMSS_RESET_N", + "PRB_SC_GPIO_139", + + "SAR1_IRQ_ODL", /* 140 */ + "SAR0_IRQ_ODL", + "PRB_SC_GPIO_142", + "", + "WCD_SWR_TX_CLK", + "WCD_SWR_TX_DATA0", + "WCD_SWR_TX_DATA1", + "WCD_SWR_RX_CLK", + "WCD_SWR_RX_DATA0", + "WCD_SWR_RX_DATA1", + + "DMIC01_CLK", /* 150 */ + "DMIC01_DATA", + "DMIC23_CLK", + "DMIC23_DATA", + "", + "", + "EC_IN_RW_ODL", + "HUB_EN", + "WCD_SWR_TX_DATA2", + "", + + "", /* 160 */ + "", + "", + "", + "", + "", + "", + "", + "", + "", + + "", /* 170 */ + "MOS_BLE_UART_TX", + "MOS_BLE_UART_RX", + "", + ""; +}; |