diff options
Diffstat (limited to 'dts/src/arm64/qcom/sc7280-qcard.dtsi')
| -rw-r--r-- | dts/src/arm64/qcom/sc7280-qcard.dtsi | 116 |
1 files changed, 92 insertions, 24 deletions
diff --git a/dts/src/arm64/qcom/sc7280-qcard.dtsi b/dts/src/arm64/qcom/sc7280-qcard.dtsi index 7adf31bb98..f9b96bd247 100644 --- a/dts/src/arm64/qcom/sc7280-qcard.dtsi +++ b/dts/src/arm64/qcom/sc7280-qcard.dtsi @@ -28,6 +28,38 @@ bluetooth0 = &bluetooth; serial0 = &uart5; serial1 = &uart7; + wifi0 = &wifi; + }; + + wcd9385: audio-codec-1 { + compatible = "qcom,wcd9385-codec"; + pinctrl-names = "default", "sleep"; + pinctrl-0 = <&wcd_reset_n>, <&us_euro_hs_sel>; + pinctrl-1 = <&wcd_reset_n_sleep>, <&us_euro_hs_sel>; + + reset-gpios = <&tlmm 83 GPIO_ACTIVE_LOW>; + us-euro-gpios = <&tlmm 81 GPIO_ACTIVE_HIGH>; + + qcom,rx-device = <&wcd_rx>; + qcom,tx-device = <&wcd_tx>; + + vdd-rxtx-supply = <&vreg_l18b_1p8>; + vdd-io-supply = <&vreg_l18b_1p8>; + vdd-buck-supply = <&vreg_l17b_1p8>; + vdd-mic-bias-supply = <&vreg_bob>; + + qcom,micbias1-microvolt = <1800000>; + qcom,micbias2-microvolt = <1800000>; + qcom,micbias3-microvolt = <1800000>; + qcom,micbias4-microvolt = <1800000>; + + qcom,mbhc-buttons-vthreshold-microvolt = <75000 150000 237000 500000 500000 + 500000 500000 500000>; + qcom,mbhc-headset-vthreshold-microvolt = <1700000>; + qcom,mbhc-headphone-vthreshold-microvolt = <50000>; + #sound-dai-cells = <1>; + + status = "disabled"; }; pm8350c_pwm_backlight: backlight { @@ -55,7 +87,7 @@ * are left out of here since they are managed elsewhere. */ - pm7325-regulators { + regulators-0 { compatible = "qcom,pm7325-rpmh-regulators"; qcom,pmic-id = "b"; @@ -156,7 +188,7 @@ }; }; - pm8350c-regulators { + regulators-1 { compatible = "qcom,pm8350c-rpmh-regulators"; qcom,pmic-id = "c"; @@ -198,9 +230,15 @@ regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>; }; + /* + * The initial design of this regulator was to use it as 3.3V, + * but due to later changes in design it was changed to 1.8V. + * The original name is kept due to same schematic. + */ + ts_avccio: vreg_l3c_3p0: ldo3 { - regulator-min-microvolt = <2800000>; - regulator-max-microvolt = <3540000>; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <1800000>; regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>; }; @@ -304,9 +342,8 @@ /* ADDITIONS TO NODES DEFINED IN PARENT DEVICE TREE FILES */ -&ipa { - status = "okay"; - modem-init; +&lpass_va_macro { + vdd-micb-supply = <&vreg_bob>; }; /* NOTE: Not all Qcards have eDP connector stuffed */ @@ -317,14 +354,9 @@ backlight = <&pm8350c_pwm_backlight>; - ports { - #address-cells = <1>; - #size-cells = <0>; - port@0 { - reg = <0>; - edp_panel_in: endpoint { - remote-endpoint = <&mdss_edp_out>; - }; + port { + edp_panel_in: endpoint { + remote-endpoint = <&mdss_edp_out>; }; }; }; @@ -351,13 +383,13 @@ }; &pmk8350_vadc { - pmk8350-die-temp@3 { + channel@3 { reg = <PMK8350_ADC7_DIE_TEMP>; label = "pmk8350_die_temp"; qcom,pre-scaling = <1 1>; }; - pmr735a-die-temp@403 { + channel@403 { reg = <PMR735A_ADC7_DIE_TEMP>; label = "pmr735a_die_temp"; qcom,pre-scaling = <1 1>; @@ -378,6 +410,22 @@ no-sdio; }; +&swr0 { + wcd_rx: codec@0,4 { + compatible = "sdw20217010d00"; + reg = <0 4>; + qcom,rx-port-mapping = <1 2 3 4 5>; + }; +}; + +&swr1 { + wcd_tx: codec@0,3 { + compatible = "sdw20217010d00"; + reg = <0 3>; + qcom,tx-port-mapping = <1 2 3 4>; + }; +}; + uart_dbg: &uart5 { compatible = "qcom,geni-debug-uart"; status = "okay"; @@ -541,7 +589,7 @@ mos_bt_uart: &uart7 { }; &tlmm { - mos_bt_en: mos-bt-en { + mos_bt_en: mos-bt-en-state { pins = "gpio85"; function = "gpio"; drive-strength = <2>; @@ -549,7 +597,7 @@ mos_bt_uart: &uart7 { }; /* For mos_bt_uart */ - qup_uart7_sleep_cts: qup-uart7-sleep-cts { + qup_uart7_sleep_cts: qup-uart7-sleep-cts-state { pins = "gpio28"; function = "gpio"; /* @@ -563,7 +611,7 @@ mos_bt_uart: &uart7 { }; /* For mos_bt_uart */ - qup_uart7_sleep_rts: qup-uart7-sleep-rts { + qup_uart7_sleep_rts: qup-uart7-sleep-rts-state { pins = "gpio29"; function = "gpio"; /* @@ -576,7 +624,7 @@ mos_bt_uart: &uart7 { }; /* For mos_bt_uart */ - qup_uart7_sleep_rx: qup-uart7-sleep-rx { + qup_uart7_sleep_rx: qup-uart7-sleep-rx-state { pins = "gpio31"; function = "gpio"; /* @@ -588,7 +636,7 @@ mos_bt_uart: &uart7 { }; /* For mos_bt_uart */ - qup_uart7_sleep_tx: qup-uart7-sleep-tx { + qup_uart7_sleep_tx: qup-uart7-sleep-tx-state { pins = "gpio30"; function = "gpio"; /* @@ -598,15 +646,35 @@ mos_bt_uart: &uart7 { bias-pull-up; }; - ts_int_conn: ts-int-conn { + ts_int_conn: ts-int-conn-state { pins = "gpio55"; function = "gpio"; bias-pull-up; }; - ts_rst_conn: ts-rst-conn { + ts_rst_conn: ts-rst-conn-state { pins = "gpio54"; function = "gpio"; drive-strength = <2>; }; + + us_euro_hs_sel: us-euro-hs-sel-state { + pins = "gpio81"; + function = "gpio"; + bias-pull-down; + drive-strength = <2>; + }; + + wcd_reset_n: wcd-reset-n-state { + pins = "gpio83"; + function = "gpio"; + drive-strength = <8>; + }; + + wcd_reset_n_sleep: wcd-reset-n-sleep-state { + pins = "gpio83"; + function = "gpio"; + drive-strength = <8>; + bias-disable; + }; }; |