From ebde8820a04dd73a09f50ba84b8cf8ec3773d6ba Mon Sep 17 00:00:00 2001 From: Sascha Hauer Date: Fri, 6 Oct 2017 06:12:41 +0200 Subject: dts: update to v4.14-rc1 Signed-off-by: Sascha Hauer --- dts/Bindings/iio/imu/st_lsm6dsx.txt | 8 ++++++++ 1 file changed, 8 insertions(+) (limited to 'dts/Bindings/iio/imu') diff --git a/dts/Bindings/iio/imu/st_lsm6dsx.txt b/dts/Bindings/iio/imu/st_lsm6dsx.txt index 6f28ff55f3..1ff1af799c 100644 --- a/dts/Bindings/iio/imu/st_lsm6dsx.txt +++ b/dts/Bindings/iio/imu/st_lsm6dsx.txt @@ -11,6 +11,14 @@ Required properties: Optional properties: - st,drdy-int-pin: the pin on the package that will be used to signal "data ready" (valid values: 1 or 2). +- drive-open-drain: the interrupt/data ready line will be configured + as open drain, which is useful if several sensors share the same + interrupt line. This is a boolean property. + (This binding is taken from pinctrl/pinctrl-bindings.txt) + If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or + IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line + when it is not active, whereas a pull-up one is needed when interrupt + line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING. - interrupt-parent: should be the phandle for the interrupt controller - interrupts: interrupt mapping for IRQ. It should be configured with flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or -- cgit v1.2.3