From 957bb6b6bcebc4c36f5f284dfb58d489e81016c6 Mon Sep 17 00:00:00 2001 From: Sascha Hauer Date: Fri, 10 Mar 2017 08:56:15 +0100 Subject: dts: update to v4.11-rc1 Signed-off-by: Sascha Hauer --- dts/Bindings/media/i2c/toshiba,et8ek8.txt | 48 +++++++++++++++++++++++++++++++ 1 file changed, 48 insertions(+) create mode 100644 dts/Bindings/media/i2c/toshiba,et8ek8.txt (limited to 'dts/Bindings/media/i2c/toshiba,et8ek8.txt') diff --git a/dts/Bindings/media/i2c/toshiba,et8ek8.txt b/dts/Bindings/media/i2c/toshiba,et8ek8.txt new file mode 100644 index 0000000000..0b7b6a4d84 --- /dev/null +++ b/dts/Bindings/media/i2c/toshiba,et8ek8.txt @@ -0,0 +1,48 @@ +Toshiba et8ek8 5MP sensor + +Toshiba et8ek8 5MP sensor is an image sensor found in Nokia N900 device + +More detailed documentation can be found in +Documentation/devicetree/bindings/media/video-interfaces.txt . + + +Mandatory properties +-------------------- + +- compatible: "toshiba,et8ek8" +- reg: I2C address (0x3e, or an alternative address) +- vana-supply: Analogue voltage supply (VANA), 2.8 volts +- clocks: External clock to the sensor +- clock-frequency: Frequency of the external clock to the sensor. Camera + driver will set this frequency on the external clock. The clock frequency is + a pre-determined frequency known to be suitable to the board. +- reset-gpios: XSHUTDOWN GPIO. The XSHUTDOWN signal is active low. The sensor + is in hardware standby mode when the signal is in the low state. + + +Endpoint node mandatory properties +---------------------------------- + +- remote-endpoint: A phandle to the bus receiver's endpoint node. + + +Example +------- + +&i2c3 { + clock-frequency = <400000>; + + cam1: camera@3e { + compatible = "toshiba,et8ek8"; + reg = <0x3e>; + vana-supply = <&vaux4>; + clocks = <&isp 0>; + clock-frequency = <9600000>; + reset-gpio = <&gpio4 6 GPIO_ACTIVE_HIGH>; /* 102 */ + port { + csi_cam1: endpoint { + remote-endpoint = <&csi_out1>; + }; + }; + }; +}; -- cgit v1.2.3