From 00ce25c6dcdae5582ae4be37147ab33678adc995 Mon Sep 17 00:00:00 2001 From: Sascha Hauer Date: Fri, 25 Apr 2014 11:22:32 +0200 Subject: Add devicetree source files as of Linux-3.15-rc2 This adds the Linux dts files to barebox. The dts files are generated from Ian Campbells device-tree-rebasing.git: git://xenbits.xen.org/people/ianc/device-tree-rebasing.git The dts are found in dts/ in the barebox repository and will be updated from upstream regularly, probably for each upstream -rc. To keep the synchronization with upstream easy no changes to the original files are allowed under dts/. Instead changes to upstream dts files will be done using overlays in arch/$ARCH/dts/. Signed-off-by: Sascha Hauer --- dts/Bindings/misc/ifm-csi.txt | 41 +++++++++++++++++++++++++++++++++++++++++ 1 file changed, 41 insertions(+) create mode 100644 dts/Bindings/misc/ifm-csi.txt (limited to 'dts/Bindings/misc/ifm-csi.txt') diff --git a/dts/Bindings/misc/ifm-csi.txt b/dts/Bindings/misc/ifm-csi.txt new file mode 100644 index 0000000000..5bdfffb0b9 --- /dev/null +++ b/dts/Bindings/misc/ifm-csi.txt @@ -0,0 +1,41 @@ +IFM camera sensor interface on mpc5200 LocalPlus bus + +Required properties: +- compatible: "ifm,o2d-csi" +- reg: specifies sensor chip select number and associated address range +- interrupts: external interrupt line number and interrupt sense mode + of the interrupt line signaling frame valid events +- gpios: three gpio-specifiers for "capture", "reset" and "master enable" + GPIOs (strictly in this order). +- ifm,csi-clk-handle: the phandle to a node in the DT describing the sensor + clock generator. This node is usually a general purpose timer controller. +- ifm,csi-addr-bus-width: address bus width (valid values are 16, 24, 25) +- ifm,csi-data-bus-width: data bus width (valid values are 8 and 16) +- ifm,csi-wait-cycles: sensor bus wait cycles + +Optional properties: +- ifm,csi-byte-swap: if this property is present, the byte swapping on + the bus will be enabled. + +Example: + + csi@3,0 { + compatible = "ifm,o2d-csi"; + reg = <3 0 0x00100000>; /* CS 3, 1 MiB range */ + interrupts = <1 1 2>; /* IRQ1, edge falling */ + + ifm,csi-clk-handle = <&timer7>; + gpios = <&gpio_simple 23 0 /* image_capture */ + &gpio_simple 26 0 /* image_reset */ + &gpio_simple 29 0>; /* image_master_en */ + + ifm,csi-addr-bus-width = <24>; + ifm,csi-data-bus-width = <8>; + ifm,csi-wait-cycles = <0>; + }; + +The base address of the used chip select is specified in the +ranges property of the parent localbus node, for example: + + ranges = <0 0 0xff000000 0x01000000 + 3 0 0xe3000000 0x00100000>; -- cgit v1.2.3