# SPDX-License-Identifier: GPL-2.0-only
menuconfig REGULATOR
	bool "voltage regulator support"

if REGULATOR

config REGULATOR_FIXED
	bool "fixed/gpio regulator"
	depends on GENERIC_GPIO
	depends on OFDEVICE
	help
	  This enables a simple fixed regulator. It is used for regulators
	  which are not software controllable or controllable via gpio.

config REGULATOR_BCM283X
	bool
	depends on ARCH_BCM283X
	default y

config REGULATOR_PFUZE
	bool "Freescale PFUZE100/200/3000 regulator driver"
	depends on I2C
	depends on ARCH_IMX || COMPILE_TEST

config REGULATOR_STM32_PWR
	bool "STMicroelectronics STM32 PWR"
	depends on ARCH_STM32MP
	help
	  This driver supports internal regulators (1V1, 1V8, 3V3) in the
	  STMicroelectronics STM32 chips.

config REGULATOR_STM32_VREFBUF
	tristate "STMicroelectronics STM32 VREFBUF"
	depends on ARCH_STM32 || COMPILE_TEST
	help
	  This driver supports STMicroelectronics STM32 VREFBUF (voltage
	  reference buffer) which can be used as voltage reference for
	  internal ADCs, DACs and also for external components through
	  dedicated Vref+ pin.

config REGULATOR_STPMIC1
	tristate "STMicroelectronics STPMIC1 PMIC Regulators"
	depends on MFD_STPMIC1
	help
	  This driver supports STMicroelectronics STPMIC1 PMIC voltage
	  regulators and switches. The STPMIC1 regulators supply power to
	  an application processor as well as to external system
	  peripherals such as DDR, Flash memories and system devices.

config REGULATOR_ANATOP
	tristate "Freescale i.MX on-chip ANATOP LDO regulators"
	depends on MFD_SYSCON
	help
	  Say y here to support Freescale i.MX on-chip ANATOP LDOs
	  regulators. It is recommended that this option be
	  enabled on i.MX6 platform.


config REGULATOR_ARM_SCMI
	tristate "SCMI based regulator driver"
	depends on ARM_SCMI_PROTOCOL && OFDEVICE
	help
	  This adds the regulator driver support for ARM platforms using SCMI
	  protocol for device voltage management.
	  This driver uses SCMI Message Protocol driver to interact with the
	  firmware providing the device Voltage functionality.

config REGULATOR_RK808
	tristate "Rockchip RK805/RK808/RK809/RK817/RK818 Power regulators"
	depends on MFD_RK808
	help
	  Select this option to enable the power regulator of ROCKCHIP
	  PMIC RK805,RK809&RK817,RK808 and RK818.
	  This driver supports the control of different power rails of device
	  through regulator interface. The device supports multiple DCDC/LDO
	  outputs which can be controlled by i2c communication.

endif