* Calxeda AHCI SATA Controller SATA nodes are defined to describe on-chip Serial ATA controllers. The Calxeda SATA controller mostly conforms to the AHCI interface with some special extensions to add functionality. Each SATA controller should have its own node. Required properties: - compatible : compatible list, contains "calxeda,hb-ahci" - interrupts : - reg : Optional properties: - dma-coherent : Present if dma operations are coherent - calxeda,port-phys : phandle-combophy and lane assignment, which maps each SATA port to a combophy and a lane within that combophy - calxeda,sgpio-gpio: phandle-gpio bank, bit offset, and default on or off, which indicates that the driver supports SGPIO indicator lights using the indicated GPIOs - calxeda,led-order : a u32 array that map port numbers to offsets within the SGPIO bitstream. - calxeda,tx-atten : a u32 array that contains TX attenuation override codes, one per port. The upper 3 bytes are always 0 and thus ignored. - calxeda,pre-clocks : a u32 that indicates the number of additional clock cycles to transmit before sending an SGPIO pattern - calxeda,post-clocks: a u32 that indicates the number of additional clock cycles to transmit after sending an SGPIO pattern Example: sata@ffe08000 { compatible = "calxeda,hb-ahci"; reg = <0xffe08000 0x1000>; interrupts = <115>; dma-coherent; calxeda,port-phys = <&combophy5 0 &combophy0 0 &combophy0 1 &combophy0 2 &combophy0 3>; calxeda,sgpio-gpio =<&gpioh 5 1 &gpioh 6 1 &gpioh 7 1>; calxeda,led-order = <4 0 1 2 3>; calxeda,tx-atten = <0xff 22 0xff 0xff 23>; calxeda,pre-clocks = <10>; calxeda,post-clocks = <0>; };