Sharp Microelectronics 10.1" WQXGA TFT LCD panel This panel requires a dual-channel DSI host to operate. It supports two modes: - left-right: each channel drives the left or right half of the screen - even-odd: each channel drives the even or odd lines of the screen Each of the DSI channels controls a separate DSI peripheral. The peripheral driven by the first link (DSI-LINK1), left or even, is considered the primary peripheral and controls the device. The 'link2' property contains a phandle to the peripheral driven by the second link (DSI-LINK2, right or odd). Note that in video mode the DSI-LINK1 interface always provides the left/even pixels and DSI-LINK2 always provides the right/odd pixels. In command mode it is possible to program either link to drive the left/even or right/odd pixels but for the sake of consistency this binding assumes that the same assignment is chosen as for video mode. Required properties: - compatible: should be "sharp,lq101r1sx01" - reg: DSI virtual channel of the peripheral Required properties (for DSI-LINK1 only): - link2: phandle to the DSI peripheral on the secondary link. Note that the presence of this property marks the containing node as DSI-LINK1. - power-supply: phandle of the regulator that provides the supply voltage Optional properties (for DSI-LINK1 only): - backlight: phandle of the backlight device attached to the panel Example: dsi@54300000 { panel: panel@0 { compatible = "sharp,lq101r1sx01"; reg = <0>; link2 = <&secondary>; power-supply = <...>; backlight = <...>; }; }; dsi@54400000 { secondary: panel@0 { compatible = "sharp,lq101r1sx01"; reg = <0>; }; };