NXP LPC18xx/43xx DMA MUX (DMA request router) Required properties: - compatible: "nxp,lpc1850-dmamux" - reg: Memory map for accessing module - #dma-cells: Should be set to <3>. * 1st cell contain the master dma request signal * 2nd cell contain the mux value (0-3) for the peripheral * 3rd cell contain either 1 or 2 depending on the AHB master used. - dma-requests: Number of DMA requests for the mux - dma-masters: phandle pointing to the DMA controller The DMA controller node need to have the following poroperties: - dma-requests: Number of DMA requests the controller can handle Example: dmac: dma@40002000 { compatible = "nxp,lpc1850-gpdma", "arm,pl080", "arm,primecell"; arm,primecell-periphid = <0x00041080>; reg = <0x40002000 0x1000>; interrupts = <2>; clocks = <&ccu1 CLK_CPU_DMA>; clock-names = "apb_pclk"; #dma-cells = <2>; dma-channels = <8>; dma-requests = <16>; lli-bus-interface-ahb1; lli-bus-interface-ahb2; mem-bus-interface-ahb1; mem-bus-interface-ahb2; memcpy-burst-size = <256>; memcpy-bus-width = <32>; }; dmamux: dma-mux { compatible = "nxp,lpc1850-dmamux"; #dma-cells = <3>; dma-requests = <64>; dma-masters = <&dmac>; }; uart0: serial@40081000 { compatible = "nxp,lpc1850-uart", "ns16550a"; reg = <0x40081000 0x1000>; reg-shift = <2>; interrupts = <24>; clocks = <&ccu2 CLK_APB0_UART0>, <&ccu1 CLK_CPU_UART0>; clock-names = "uartclk", "reg"; dmas = <&dmamux 1 1 2 &dmamux 2 1 2>; dma-names = "tx", "rx"; };