FocalTech EDT-FT5x06 Polytouch driver ===================================== There are 3 variants of the chip for various touch panel sizes FT5206GE1 2.8" .. 3.8" FT5306DE4 4.3" .. 7" FT5406EE8 7" .. 8.9" FT5506EEG 7" .. 8.9" The software interface is identical for all those chips, so that currently there is no need for the driver to distinguish between the different chips. Nevertheless distinct compatible strings are used so that a distinction can be added if necessary without changing the DT bindings. Required properties: - compatible: "edt,edt-ft5206" or: "edt,edt-ft5306" or: "edt,edt-ft5406" or: "edt,edt-ft5506" or: "focaltech,ft6236" - reg: I2C slave address of the chip (0x38) - interrupt-parent: a phandle pointing to the interrupt controller serving the interrupt for this chip - interrupts: interrupt specification for the touchdetect interrupt Optional properties: - reset-gpios: GPIO specification for the RESET input - wake-gpios: GPIO specification for the WAKE input - pinctrl-names: should be "default" - pinctrl-0: a phandle pointing to the pin settings for the control gpios - threshold: allows setting the "click"-threshold in the range from 20 to 80. - gain: allows setting the sensitivity in the range from 0 to 31. Note that lower values indicate higher sensitivity. - offset: allows setting the edge compensation in the range from 0 to 31. - touchscreen-size-x : See touchscreen.txt - touchscreen-size-y : See touchscreen.txt - touchscreen-fuzz-x : See touchscreen.txt - touchscreen-fuzz-y : See touchscreen.txt - touchscreen-inverted-x : See touchscreen.txt - touchscreen-inverted-y : See touchscreen.txt - touchscreen-swapped-x-y : See touchscreen.txt Example: polytouch: edt-ft5x06@38 { compatible = "edt,edt-ft5406", "edt,edt-ft5x06"; reg = <0x38>; pinctrl-names = "default"; pinctrl-0 = <&edt_ft5x06_pins>; interrupt-parent = <&gpio2>; interrupts = <5 IRQ_TYPE_EDGE_FALLING>; reset-gpios = <&gpio2 6 GPIO_ACTIVE_LOW>; wake-gpios = <&gpio4 9 GPIO_ACTIVE_HIGH>; };