* TPS65086 Power Management Integrated Circuit (PMIC) bindings Required properties: - compatible : Should be "ti,tps65086". - reg : I2C slave address. - interrupts : The interrupt line the device is connected to. - interrupt-controller : Marks the device node as an interrupt controller. - #interrupt-cells : The number of cells to describe an IRQ, should be 2. The first cell is the IRQ number. The second cell is the flags, encoded as trigger masks from ../interrupt-controller/interrupts.txt. - gpio-controller : Marks the device node as a GPIO Controller. - #gpio-cells : Should be two. The first cell is the pin number and the second cell is used to specify flags. See ../gpio/gpio.txt for more information. - regulators: : List of child nodes that specify the regulator initialization data. Child nodes must be named after their hardware counterparts: buck[1-6], ldoa[1-3], swa1, swb[1-2], and vtt. Each child node is defined using the standard binding for regulators and the optional regulator properties defined below. Optional regulator properties: - ti,regulator-step-size-25mv : This is applicable for buck[1-6], set this if the regulator is factory set with a 25mv step voltage mapping. - ti,regulator-decay : This is applicable for buck[1-6], set this if the output needs to decay, default is for the output to slew down. Example: pmic: tps65086@5e { compatible = "ti,tps65086"; reg = <0x5e>; interrupt-parent = <&gpio1>; interrupts = <28 IRQ_TYPE_LEVEL_LOW>; interrupt-controller; #interrupt-cells = <2>; gpio-controller; #gpio-cells = <2>; regulators { buck1 { regulator-name = "vcc1"; regulator-min-microvolt = <1600000>; regulator-max-microvolt = <1600000>; regulator-boot-on; ti,regulator-decay; ti,regulator-step-size-25mv; }; }; };