* TPS65912 Power Management Integrated Circuit bindings Required properties: - compatible : Should be "ti,tps65912". - reg : Slave address or chip select number (I2C / SPI). - interrupt-parent : The parent interrupt controller. - interrupts : The interrupt line the device is connected to. - interrupt-controller : Marks the device node as an interrupt controller. - #interrupt-cells : The number of cells to describe an IRQ, should be 2. The first cell is the IRQ number. The second cell is the flags, encoded as trigger masks from ../interrupt-controller/interrupts.txt. - gpio-controller : Marks the device node as a GPIO Controller. - #gpio-cells : Should be two. The first cell is the pin number and the second cell is used to specify flags. See ../gpio/gpio.txt for more information. - regulators: : List of child nodes that specify the regulator initialization data. Child nodes must be named after their hardware counterparts: dcdc[1-4] and ldo[1-10]. Each child nodes is defined using the standard binding for regulators. Example: pmic: tps65912@2d { compatible = "ti,tps65912"; reg = <0x2d>; interrupt-parent = <&gpio1>; interrupts = <28 IRQ_TYPE_LEVEL_LOW>; interrupt-controller; #interrupt-cells = <2>; gpio-controller; #gpio-cells = <2>; regulators { dcdc1 { regulator-name = "vdd_core"; regulator-min-microvolt = <912000>; regulator-max-microvolt = <1144000>; regulator-boot-on; regulator-always-on; }; ldo1 { regulator-name = "ldo1"; regulator-min-microvolt = <1900000>; regulator-max-microvolt = <1900000>; }; }; };