Device tree bindings for Texas instruments Davinci/Keystone NAND controller This file provides information, what the device node for the davinci/keystone NAND interface contains. Documentation: Davinci DM646x - http://www.ti.com/lit/ug/sprueq7c/sprueq7c.pdf Kestone - http://www.ti.com/lit/ug/sprugz3a/sprugz3a.pdf Required properties: - compatible: "ti,davinci-nand" "ti,keystone-nand" - reg: Contains 2 offset/length values: - offset and length for the access window. - offset and length for accessing the AEMIF control registers. - ti,davinci-chipselect: number of chipselect. Indicates on the davinci_nand driver which chipselect is used for accessing the nand. Can be in the range [0-3]. Recommended properties : - ti,davinci-mask-ale: mask for ALE. Needed for executing address phase. These offset will be added to the base address for the chip select space the NAND Flash device is connected to. If not set equal to 0x08. - ti,davinci-mask-cle: mask for CLE. Needed for executing command phase. These offset will be added to the base address for the chip select space the NAND Flash device is connected to. If not set equal to 0x10. - ti,davinci-mask-chipsel: mask for chipselect address. Needed to mask addresses for given chipselect. - nand-ecc-mode: operation mode of the NAND ecc mode. ECC mode valid values for davinci driver: - "none" - "soft" - "hw" - ti,davinci-ecc-bits: used ECC bits, currently supported 1 or 4. - nand-bus-width: buswidth 8 or 16. If not present 8. - nand-on-flash-bbt: use flash based bad block table support. OOB identifier is saved in OOB area. If not present false. Deprecated properties: - ti,davinci-ecc-mode: operation mode of the NAND ecc mode. ECC mode valid values for davinci driver: - "none" - "soft" - "hw" - ti,davinci-nand-buswidth: buswidth 8 or 16. If not present 8. - ti,davinci-nand-use-bbt: use flash based bad block table support. OOB identifier is saved in OOB area. If not present false. Nand device bindings may contain additional sub-nodes describing partitions of the address space. See partition.txt for more detail. The NAND Flash timing values must be programmed in the chip select’s node of AEMIF memory-controller (see Documentation/devicetree/bindings/memory-controllers/ davinci-aemif.txt). Example(da850 EVM ): nand_cs3@62000000 { compatible = "ti,davinci-nand"; reg = <0x62000000 0x807ff 0x68000000 0x8000>; ti,davinci-chipselect = <1>; ti,davinci-mask-ale = <0>; ti,davinci-mask-cle = <0>; ti,davinci-mask-chipsel = <0>; nand-ecc-mode = "hw"; ti,davinci-ecc-bits = <4>; nand-on-flash-bbt; partition@180000 { label = "ubifs"; reg = <0x180000 0x7e80000>; }; };