* Marvell Armada 375 Ethernet Controller (PPv2) Required properties: - compatible: should be "marvell,armada-375-pp2" - reg: addresses and length of the register sets for the device. Must contain the following register sets: - common controller registers - LMS registers In addition, at least one port register set is required. - clocks: a pointer to the reference clocks for this device, consequently: - main controller clock - GOP clock - clock-names: names of used clocks, must be "pp_clk" and "gop_clk". The ethernet ports are represented by subnodes. At least one port is required. Required properties (port): - interrupts: interrupt for the port - port-id: should be '0' or '1' for ethernet ports, and '2' for the loopback port - phy-mode: See ethernet.txt file in the same directory Optional properties (port): - marvell,loopback: port is loopback mode - phy: a phandle to a phy node defining the PHY address (as the reg property, a single integer). Note: if this property isn't present, then fixed link is assumed, and the 'fixed-link' property is mandatory. Example: ethernet@f0000 { compatible = "marvell,armada-375-pp2"; reg = <0xf0000 0xa000>, <0xc0000 0x3060>, <0xc4000 0x100>, <0xc5000 0x100>; clocks = <&gateclk 3>, <&gateclk 19>; clock-names = "pp_clk", "gop_clk"; status = "okay"; eth0: eth0@c4000 { interrupts = ; port-id = <0>; status = "okay"; phy = <&phy0>; phy-mode = "gmii"; }; eth1: eth1@c5000 { interrupts = ; port-id = <1>; status = "okay"; phy = <&phy3>; phy-mode = "gmii"; }; };