Properties for an MDIO bus multiplexer consumer device This is a special case of MDIO mux when MDIO mux is defined as a consumer of a mux producer device. The mux producer can be of any type like mmio mux producer, gpio mux producer or generic register based mux producer. Required properties in addition to the MDIO Bus multiplexer properties: - compatible : should be "mmio-mux-multiplexer" - mux-controls : mux controller node to use for operating the mux - mdio-parent-bus : phandle to the parent MDIO bus. each child node of mdio bus multiplexer consumer device represent a mdio bus. for more information please refer Documentation/devicetree/bindings/mux/mux-controller.txt and Documentation/devicetree/bindings/net/mdio-mux.txt Example: In below example the Mux producer and consumer are separate nodes. &i2c0 { fpga@66 { // fpga connected to i2c compatible = "fsl,lx2160aqds-fpga", "fsl,fpga-qixis-i2c", "simple-mfd"; reg = <0x66>; mux: mux-controller { // Mux Producer compatible = "reg-mux"; #mux-control-cells = <1>; mux-reg-masks = <0x54 0xf8>, /* 0: reg 0x54, bits 7:3 */ <0x54 0x07>; /* 1: reg 0x54, bits 2:0 */ }; }; }; mdio-mux-1 { // Mux consumer compatible = "mdio-mux-multiplexer"; mux-controls = <&mux 0>; mdio-parent-bus = <&emdio1>; #address-cells = <1>; #size-cells = <0>; mdio@0 { reg = <0x0>; #address-cells = <1>; #size-cells = <0>; }; mdio@8 { reg = <0x8>; #address-cells = <1>; #size-cells = <0>; }; .. .. }; mdio-mux-2 { // Mux consumer compatible = "mdio-mux-multiplexer"; mux-controls = <&mux 1>; mdio-parent-bus = <&emdio2>; #address-cells = <1>; #size-cells = <0>; mdio@0 { reg = <0x0>; #address-cells = <1>; #size-cells = <0>; }; mdio@1 { reg = <0x1>; #address-cells = <1>; #size-cells = <0>; }; .. .. };