* Solomon SSD1307 Framebuffer Driver Required properties: - compatible: Should be "solomon,fb-". The only supported bus for now is i2c, and the supported chips are ssd1305, ssd1306 and ssd1307. - reg: Should contain address of the controller on the I2C bus. Most likely 0x3c or 0x3d - pwm: Should contain the pwm to use according to the OF device tree PWM specification [0]. Only required for the ssd1307. - reset-gpios: Should contain the GPIO used to reset the OLED display - solomon,height: Height in pixel of the screen driven by the controller - solomon,width: Width in pixel of the screen driven by the controller - solomon,page-offset: Offset of pages (band of 8 pixels) that the screen is mapped to. Optional properties: - reset-active-low: Is the reset gpio is active on physical low? - solomon,segment-no-remap: Display needs normal (non-inverted) data column to segment mapping - solomon,com-seq: Display uses sequential COM pin configuration - solomon,com-lrremap: Display uses left-right COM pin remap - solomon,com-invdir: Display uses inverted COM pin scan direction - solomon,com-offset: Number of the COM pin wired to the first display line - solomon,prechargep1: Length of deselect period (phase 1) in clock cycles. - solomon,prechargep2: Length of precharge period (phase 2) in clock cycles. This needs to be the higher, the higher the capacitance of the OLED's pixels is [0]: Documentation/devicetree/bindings/pwm/pwm.txt Examples: ssd1307: oled@3c { compatible = "solomon,ssd1307fb-i2c"; reg = <0x3c>; pwms = <&pwm 4 3000>; reset-gpios = <&gpio2 7>; reset-active-low; }; ssd1306: oled@3c { compatible = "solomon,ssd1306fb-i2c"; reg = <0x3c>; pwms = <&pwm 4 3000>; reset-gpios = <&gpio2 7>; reset-active-low; solomon,com-lrremap; solomon,com-invdir; solomon,com-offset = <32>; };