From c42aa775cc8a8ca558db0cc75979fb8e16667447 Mon Sep 17 00:00:00 2001 From: Nicolas Ferre Date: Thu, 20 Nov 2008 15:59:12 +0100 Subject: atmel-mci: move atmel-mci.h file to include/linux Needed to use the atmel-mci driver in an architecture independant maner. Signed-off-by: Nicolas Ferre Signed-off-by: Haavard Skinnemoen --- arch/avr32/include/asm/atmel-mci.h | 39 -------------------------------------- 1 file changed, 39 deletions(-) delete mode 100644 arch/avr32/include/asm/atmel-mci.h (limited to 'arch/avr32/include/asm') diff --git a/arch/avr32/include/asm/atmel-mci.h b/arch/avr32/include/asm/atmel-mci.h deleted file mode 100644 index 59f3fadd0b68..000000000000 --- a/arch/avr32/include/asm/atmel-mci.h +++ /dev/null @@ -1,39 +0,0 @@ -#ifndef __ASM_AVR32_ATMEL_MCI_H -#define __ASM_AVR32_ATMEL_MCI_H - -#define ATMEL_MCI_MAX_NR_SLOTS 2 - -struct dma_slave; - -/** - * struct mci_slot_pdata - board-specific per-slot configuration - * @bus_width: Number of data lines wired up the slot - * @detect_pin: GPIO pin wired to the card detect switch - * @wp_pin: GPIO pin wired to the write protect sensor - * - * If a given slot is not present on the board, @bus_width should be - * set to 0. The other fields are ignored in this case. - * - * Any pins that aren't available should be set to a negative value. - * - * Note that support for multiple slots is experimental -- some cards - * might get upset if we don't get the clock management exactly right. - * But in most cases, it should work just fine. - */ -struct mci_slot_pdata { - unsigned int bus_width; - int detect_pin; - int wp_pin; -}; - -/** - * struct mci_platform_data - board-specific MMC/SDcard configuration - * @dma_slave: DMA slave interface to use in data transfers, or NULL. - * @slot: Per-slot configuration data. - */ -struct mci_platform_data { - struct dma_slave *dma_slave; - struct mci_slot_pdata slot[ATMEL_MCI_MAX_NR_SLOTS]; -}; - -#endif /* __ASM_AVR32_ATMEL_MCI_H */ -- cgit v1.2.3