dts: update to v5.12-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 0 insertions, 45 deletions

diff --git a/dts/Bindings/iio/gyroscope/invensense,mpu3050.txt b/dts/Bindings/iio/gyroscope/invensense,mpu3050.txt
deleted file mode 100644
index 233fe207ad..0000000000
--- a/dts/Bindings/iio/gyroscope/invensense,mpu3050.txt
+++ /dev/null
@@ -1,45 +0,0 @@
-Invensense MPU-3050 Gyroscope device tree bindings
-
-Required properties:
-  - compatible : should be "invensense,mpu3050"
-  - reg : the I2C address of the sensor
-
-Optional properties:
-  - interrupts : interrupt mapping for the trigger interrupt from the
-    internal oscillator. The following IRQ modes are supported:
-    IRQ_TYPE_EDGE_RISING, IRQ_TYPE_EDGE_FALLING, IRQ_TYPE_LEVEL_HIGH and
-    IRQ_TYPE_LEVEL_LOW. The driver should detect and configure the hardware
-    for the desired interrupt type.
-  - vdd-supply : supply regulator for the main power voltage.
-  - vlogic-supply : supply regulator for the signal voltage.
-  - mount-matrix : see iio/mount-matrix.txt
-
-Optional subnodes:
-  - The MPU-3050 will pass through and forward the I2C signals from the
-    incoming I2C bus, alternatively drive traffic to a slave device (usually
-    an accelerometer) on its own initiative. Therefore is supports a subnode
-    i2c gate node. For details see: i2c/i2c-gate.txt
-
-Example:
-
-mpu3050@68 {
-	compatible = "invensense,mpu3050";
-	reg = <0x68>;
-	interrupt-parent = <&foo>;
-	interrupts = <12 IRQ_TYPE_EDGE_FALLING>;
-	vdd-supply = <&bar>;
-	vlogic-supply = <&baz>;
-
-	/* External I2C interface */
-	i2c-gate {
-		#address-cells = <1>;
-		#size-cells = <0>;
-
-		fnord@18 {
-			compatible = "fnord";
-			reg = <0x18>;
-			interrupt-parent = <&foo>;
-			interrupts = <13 IRQ_TYPE_EDGE_FALLING>;
-		};
-	};
-};