dts: update to v4.12-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 37 insertions, 0 deletions

diff --git a/dts/Bindings/net/mdio.txt b/dts/Bindings/net/mdio.txt
new file mode 100644
index 0000000000..96a53f89aa
--- /dev/null
+++ b/dts/Bindings/net/mdio.txt
@@ -0,0 +1,37 @@
+Common MDIO bus properties.
+
+These are generic properties that can apply to any MDIO bus.
+
+Optional properties:
+- reset-gpios: One GPIO that control the RESET lines of all PHYs on that MDIO
+  bus.
+- reset-delay-us: RESET pulse width in microseconds.
+
+A list of child nodes, one per device on the bus is expected. These
+should follow the generic phy.txt, or a device specific binding document.
+
+The 'reset-delay-us' indicates the RESET signal pulse width in microseconds and
+applies to all PHY devices. It must therefore be appropriately determined based
+on all PHY requirements (maximum value of all per-PHY RESET pulse widths).
+
+Example :
+This example shows these optional properties, plus other properties
+required for the TI Davinci MDIO driver.
+
+	davinci_mdio: ethernet@0x5c030000 {
+		compatible = "ti,davinci_mdio";
+		reg = <0x5c030000 0x1000>;
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		reset-gpios = <&gpio2 5 GPIO_ACTIVE_LOW>;
+		reset-delay-us = <2>;
+
+		ethphy0: ethernet-phy@1 {
+			reg = <1>;
+		};
+
+		ethphy1: ethernet-phy@3 {
+			reg = <3>;
+		};
+	};