dts: update to v6.5-rc1

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 0 insertions, 38 deletions

diff --git a/dts/Bindings/rtc/isil,isl1208.txt b/dts/Bindings/rtc/isil,isl1208.txt
deleted file mode 100644
index 51f003006f..0000000000
--- a/dts/Bindings/rtc/isil,isl1208.txt
+++ /dev/null
@@ -1,38 +0,0 @@
-Intersil ISL1209/19 I2C RTC/Alarm chip with event in
-
-ISL12X9 have additional pins EVIN and #EVDET for tamper detection, while the
-ISL1208 and ISL1218 do not.  They are all use the same driver with the bindings
-described here, with chip specific properties as noted.
-
-Required properties supported by the device:
- - "compatible": Should be one of the following:
-		- "isil,isl1208"
-		- "isil,isl1209"
-		- "isil,isl1218"
-		- "isil,isl1219"
- - "reg": I2C bus address of the device
-
-Optional properties:
- - "interrupt-names": list which may contains "irq" and "evdet"
-	evdet applies to isl1209 and isl1219 only
- - "interrupts": list of interrupts for "irq" and "evdet"
-	evdet applies to isl1209 and isl1219 only
- - "isil,ev-evienb": Enable or disable internal pull on EVIN pin
-	Applies to isl1209 and isl1219 only
-	Possible values are 0 and 1
-	Value 0 enables internal pull-up on evin pin, 1 disables it.
-	Default will leave the non-volatile configuration of the pullup
-	as is.
-
-Example isl1219 node with #IRQ pin connected to SoC gpio1 pin12 and #EVDET pin
-connected to SoC gpio2 pin 24 and internal pull-up enabled in EVIN pin.
-
-	isl1219: rtc@68 {
-		compatible = "isil,isl1219";
-		reg = <0x68>;
-		interrupt-names = "irq", "evdet";
-		interrupts-extended = <&gpio1 12 IRQ_TYPE_EDGE_FALLING>,
-			<&gpio2 24 IRQ_TYPE_EDGE_FALLING>;
-		isil,ev-evienb = <1>;
-	};
-