1 files changed, 0 insertions, 52 deletions
diff --git a/dts/Bindings/regulator/max8973-regulator.txt b/dts/Bindings/regulator/max8973-regulator.txt
deleted file mode 100644
index c2c68fcc1b..0000000000
--- a/dts/Bindings/regulator/max8973-regulator.txt
+++ /dev/null
@@ -1,52 +0,0 @@
-* Maxim MAX8973 Voltage Regulator
-
-Required properties:
-
-- compatible:	must be one of following:
-			"maxim,max8973"
-			"maxim,max77621".
-- reg:		the i2c slave address of the regulator. It should be 0x1b.
-
-Any standard regulator properties can be used to configure the single max8973
-DCDC.
-
-Optional properties:
-
--maxim,externally-enable: boolean, externally control the regulator output
-		enable/disable.
--maxim,enable-gpio: GPIO for enable control. If the valid GPIO is provided
-		then externally enable control will be considered.
--maxim,dvs-gpio: GPIO which is connected to DVS pin of device.
--maxim,dvs-default-state: Default state of GPIO during initialisation.
-		1 for HIGH and 0 for LOW.
--maxim,enable-remote-sense: boolean, enable reote sense.
--maxim,enable-falling-slew-rate: boolean, enable falling slew rate.
--maxim,enable-active-discharge: boolean: enable active discharge.
--maxim,enable-frequency-shift: boolean, enable 9% frequency shift.
--maxim,enable-bias-control: boolean, enable bias control. By enabling this
-		startup delay can be reduce to 20us from 220us.
--maxim,enable-etr: boolean, enable Enhanced Transient Response.
--maxim,enable-high-etr-sensitivity: boolean, Enhanced transient response
-		circuit is enabled and set for high sensitivity. If this
-		property is available then etr will be enable default.
-
-Enhanced transient response (ETR) will affect the configuration of CKADV.
-
--junction-warn-millicelsius: u32, junction warning temperature threshold
-		in millicelsius. If die temperature crosses this level then
-		device generates the warning interrupts.
-
-Please note that thermal functionality is only supported on MAX77621. The
-supported threshold warning temperature for MAX77621 are 120 degC and 140 degC.
-
-Example:
-
-	max8973@1b {
-		compatible = "maxim,max8973";
-		reg = <0x1b>;
-
-		regulator-min-microvolt = <935000>;
-		regulator-max-microvolt = <1200000>;
-		regulator-boot-on;
-		regulator-always-on;
-	};