1 files changed, 0 insertions, 36 deletions
diff --git a/dts/Bindings/spi/qcom,spi-qcom-qspi.txt b/dts/Bindings/spi/qcom,spi-qcom-qspi.txt
deleted file mode 100644
index 1d64b61f51..0000000000
--- a/dts/Bindings/spi/qcom,spi-qcom-qspi.txt
+++ /dev/null
@@ -1,36 +0,0 @@
-Qualcomm Quad Serial Peripheral Interface (QSPI)
-
-The QSPI controller allows SPI protocol communication in single, dual, or quad
-wire transmission modes for read/write access to slaves such as NOR flash.
-
-Required properties:
-- compatible:	An SoC specific identifier followed by "qcom,qspi-v1", such as
-		"qcom,sdm845-qspi", "qcom,qspi-v1"
-- reg:		Should contain the base register location and length.
-- interrupts:	Interrupt number used by the controller.
-- clocks:	Should contain the core and AHB clock.
-- clock-names:	Should be "core" for core clock and "iface" for AHB clock.
-
-SPI slave nodes must be children of the SPI master node and can contain
-properties described in Documentation/devicetree/bindings/spi/spi-bus.txt
-
-Example:
-
-	qspi: spi@88df000 {
-		compatible = "qcom,sdm845-qspi", "qcom,qspi-v1";
-		reg = <0x88df000 0x600>;
-		#address-cells = <1>;
-		#size-cells = <0>;
-		interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
-		clock-names = "iface", "core";
-		clocks = <&gcc GCC_QSPI_CNOC_PERIPH_AHB_CLK>,
-			 <&gcc GCC_QSPI_CORE_CLK>;
-
-		flash@0 {
-			compatible = "jedec,spi-nor";
-			reg = <0>;
-			spi-max-frequency = <25000000>;
-			spi-tx-bus-width = <2>;
-			spi-rx-bus-width = <2>;
-		};
-	};