ATMEL: fix nand ecc support

So we can now choose for the board the ecc mode (ecc soft, soft bch, no ecc
and hardware).

Set ecc mode in the boards to soft as currently in the driver.

Move platform data to a common header
include/linux/platform_data/atmel_nand.h

Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
Acked-by: Hans-Christian Egtvedt <egtvedt@samfundet.no>
Acked-by: David Woodhouse <dwmw2@infradead.org>

1 files changed, 1 insertions, 12 deletions

diff --git a/arch/avr32/mach-at32ap/include/mach/board.h b/arch/avr32/mach-at32ap/include/mach/board.h
index 67b111ce332d..71733866cb4f 100644
--- a/arch/avr32/mach-at32ap/include/mach/board.h
+++ b/arch/avr32/mach-at32ap/include/mach/board.h
@@ -7,6 +7,7 @@
 #include <linux/types.h>
 #include <linux/serial.h>
 #include <linux/platform_data/macb.h>
+#include <linux/platform_data/atmel_nand.h>
 
 #define GPIO_PIN_NONE	(-1)
 
@@ -116,18 +117,6 @@ struct platform_device *
 at32_add_device_cf(unsigned int id, unsigned int extint,
 		struct cf_platform_data *data);
 
-/* NAND / SmartMedia */
-struct atmel_nand_data {
-	int	enable_pin;	/* chip enable */
-	int	det_pin;	/* card detect */
-	int	rdy_pin;	/* ready/busy */
-	u8	rdy_pin_active_low;	/* rdy_pin value is inverted */
-	u8	ale;		/* address line number connected to ALE */
-	u8	cle;		/* address line number connected to CLE */
-	u8	bus_width_16;	/* buswidth is 16 bit */
-	struct mtd_partition *parts;
-	unsigned int	num_parts;
-};
 struct platform_device *
 at32_add_device_nand(unsigned int id, struct atmel_nand_data *data);