summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/gpio/gpio-mvebu.txt')
-rw-r--r--Documentation/devicetree/bindings/gpio/gpio-mvebu.txt53
1 files changed, 53 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt b/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt
new file mode 100644
index 000000000000..a6f3bec1da7d
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-mvebu.txt
@@ -0,0 +1,53 @@
+* Marvell EBU GPIO controller
+
+Required properties:
+
+- compatible : Should be "marvell,orion-gpio", "marvell,mv78200-gpio"
+ or "marvell,armadaxp-gpio". "marvell,orion-gpio" should be used for
+ Orion, Kirkwood, Dove, Discovery (except MV78200) and Armada
+ 370. "marvell,mv78200-gpio" should be used for the Discovery
+ MV78200. "marvel,armadaxp-gpio" should be used for all Armada XP
+ SoCs (MV78230, MV78260, MV78460).
+
+- reg: Address and length of the register set for the device. Only one
+ entry is expected, except for the "marvell,armadaxp-gpio" variant
+ for which two entries are expected: one for the general registers,
+ one for the per-cpu registers.
+
+- interrupts: The list of interrupts that are used for all the pins
+ managed by this GPIO bank. There can be more than one interrupt
+ (example: 1 interrupt per 8 pins on Armada XP, which means 4
+ interrupts per bank of 32 GPIOs).
+
+- interrupt-controller: identifies the node as an interrupt controller
+
+- #interrupt-cells: specifies the number of cells needed to encode an
+ interrupt source. Should be two.
+ The first cell is the GPIO number.
+ The second cell is used to specify flags:
+ bits[3:0] trigger type and level flags:
+ 1 = low-to-high edge triggered.
+ 2 = high-to-low edge triggered.
+ 4 = active high level-sensitive.
+ 8 = active low level-sensitive.
+
+- gpio-controller: marks the device node as a gpio controller
+
+- ngpios: number of GPIOs this controller has
+
+- #gpio-cells: Should be two. The first cell is the pin number. The
+ second cell is reserved for flags, unused at the moment.
+
+Example:
+
+ gpio0: gpio@d0018100 {
+ compatible = "marvell,armadaxp-gpio";
+ reg = <0xd0018100 0x40>,
+ <0xd0018800 0x30>;
+ ngpios = <32>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ interrupts = <16>, <17>, <18>, <19>;
+ };