Add devicetree source files as of Linux-3.15-rc2

This adds the Linux dts files to barebox. The dts files are
generated from Ian Campbells device-tree-rebasing.git:

git://xenbits.xen.org/people/ianc/device-tree-rebasing.git

The dts are found in dts/ in the barebox repository and
will be updated from upstream regularly, probably for each upstream
-rc.

To keep the synchronization with upstream easy no changes to
the original files are allowed under dts/. Instead changes to
upstream dts files will be done using overlays in arch/$ARCH/dts/.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 36 insertions, 0 deletions

diff --git a/dts/Bindings/serial/maxim,max310x.txt b/dts/Bindings/serial/maxim,max310x.txt
new file mode 100644
index 0000000000..83a919c241
--- /dev/null
+++ b/dts/Bindings/serial/maxim,max310x.txt
@@ -0,0 +1,36 @@
+* Maxim MAX310X advanced Universal Asynchronous Receiver-Transmitter (UART)
+
+Required properties:
+- compatible: Should be one of the following:
+  - "maxim,max3107" for Maxim MAX3107,
+  - "maxim,max3108" for Maxim MAX3108,
+  - "maxim,max3109" for Maxim MAX3109,
+  - "maxim,max14830" for Maxim MAX14830.
+- reg: SPI chip select number.
+- interrupt-parent: The phandle for the interrupt controller that
+  services interrupts for this IC.
+- interrupts: Specifies the interrupt source of the parent interrupt
+  controller. The format of the interrupt specifier depends on the
+  parent interrupt controller.
+- clocks: phandle to the IC source clock.
+- clock-names: Should be "xtal" if clock is an external crystal or
+  "osc" if an external clock source is used.
+
+Optional properties:
+- gpio-controller: Marks the device node as a GPIO controller.
+- #gpio-cells: Should be two. The first cell is the GPIO number and
+  the second cell is used to specify the GPIO polarity:
+    0 = active high,
+    1 = active low.
+
+Example:
+	max14830: max14830@0 {
+		compatible = "maxim,max14830";
+		reg = <0>;
+		clocks = <&clk20m>;
+		clock-names = "osc";
+		interrupt-parent = <&gpio3>;
+		interrupts = <7 IRQ_TYPE_EDGE_FALLING>;
+		gpio-controller;
+		#gpio-cells = <2>;
+	};