Add devicetree source files as of Linux-3.15-rc2

This adds the Linux dts files to barebox. The dts files are
generated from Ian Campbells device-tree-rebasing.git:

git://xenbits.xen.org/people/ianc/device-tree-rebasing.git

The dts are found in dts/ in the barebox repository and
will be updated from upstream regularly, probably for each upstream
-rc.

To keep the synchronization with upstream easy no changes to
the original files are allowed under dts/. Instead changes to
upstream dts files will be done using overlays in arch/$ARCH/dts/.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 40 insertions, 0 deletions

diff --git a/dts/Bindings/spi/efm32-spi.txt b/dts/Bindings/spi/efm32-spi.txt
new file mode 100644
index 0000000000..130cd17e36
--- /dev/null
+++ b/dts/Bindings/spi/efm32-spi.txt
@@ -0,0 +1,40 @@
+* Energy Micro EFM32 SPI
+
+Required properties:
+- #address-cells: see spi-bus.txt
+- #size-cells: see spi-bus.txt
+- compatible: should be "energymicro,efm32-spi"
+- reg: Offset and length of the register set for the controller
+- interrupts: pair specifying rx and tx irq
+- clocks: phandle to the spi clock
+- cs-gpios: see spi-bus.txt
+
+Recommended properties :
+- efm32,location: Value to write to the ROUTE register's LOCATION bitfield to
+                  configure the pinmux for the device, see datasheet for values.
+                  If "efm32,location" property is not provided, keeping what is
+                  already configured in the hardware, so its either the reset
+                  default 0 or whatever the bootloader did.
+
+Example:
+
+spi1: spi@0x4000c400 { /* USART1 */
+	#address-cells = <1>;
+	#size-cells = <0>;
+	compatible = "energymicro,efm32-spi";
+	reg = <0x4000c400 0x400>;
+	interrupts = <15 16>;
+	clocks = <&cmu 20>;
+	cs-gpios = <&gpio 51 1>; // D3
+	efm32,location = <1>;
+	status = "ok";
+
+	ks8851@0 {
+		compatible = "ks8851";
+		spi-max-frequency = <6000000>;
+		reg = <0>;
+		interrupt-parent = <&boardfpga>;
+		interrupts = <4>;
+		status = "ok";
+	};
+};