Add devicetree source files as of Linux-3.15-rc2

This adds the Linux dts files to barebox. The dts files are
generated from Ian Campbells device-tree-rebasing.git:

git://xenbits.xen.org/people/ianc/device-tree-rebasing.git

The dts are found in dts/ in the barebox repository and
will be updated from upstream regularly, probably for each upstream
-rc.

To keep the synchronization with upstream easy no changes to
the original files are allowed under dts/. Instead changes to
upstream dts files will be done using overlays in arch/$ARCH/dts/.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>

1 files changed, 41 insertions, 0 deletions

diff --git a/dts/Bindings/input/touchscreen/tsc2007.txt b/dts/Bindings/input/touchscreen/tsc2007.txt
new file mode 100644
index 0000000000..ec365e1722
--- /dev/null
+++ b/dts/Bindings/input/touchscreen/tsc2007.txt
@@ -0,0 +1,41 @@
+* Texas Instruments tsc2007 touchscreen controller
+
+Required properties:
+- compatible: must be "ti,tsc2007".
+- reg: I2C address of the chip.
+- ti,x-plate-ohms: X-plate resistance in ohms.
+
+Optional properties:
+- gpios: the interrupt gpio the chip is connected to (trough the penirq pin).
+  The penirq pin goes to low when the panel is touched.
+  (see GPIO binding[1] for more details).
+- interrupt-parent: the phandle for the gpio controller
+  (see interrupt binding[0]).
+- interrupts: (gpio) interrupt to which the chip is connected
+  (see interrupt binding[0]).
+- ti,max-rt: maximum pressure.
+- ti,fuzzx: specifies the absolute input fuzz x value.
+  If set, it will permit noise in the data up to +- the value given to the fuzz
+  parameter, that is used to filter noise from the event stream.
+- ti,fuzzy: specifies the absolute input fuzz y value.
+- ti,fuzzz: specifies the absolute input fuzz z value.
+- ti,poll-period: how much time to wait (in milliseconds) before reading again the
+  values from the tsc2007.
+
+[0]: Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+[1]: Documentation/devicetree/bindings/gpio/gpio.txt
+
+Example:
+	&i2c1 {
+		/* ... */
+		tsc2007@49 {
+			compatible = "ti,tsc2007";
+			reg = <0x49>;
+			interrupt-parent = <&gpio4>;
+			interrupts = <0x0 0x8>;
+			gpios = <&gpio4 0 0>;
+			ti,x-plate-ohms = <180>;
+		};
+
+		/* ... */
+	};